Summary of Contents for Hamilton 98RH Nighthead
- Page 1 Hamilton Safe Company 98RH Nighthead Instruction sheet for replacing LeFebure 612 with Hamilton 98RH. DOCUMENT NUMBER: 08-327 LeFebure 612 Hamilton 98Rh Page 1 of 9...
- Page 2 Hamilton Safe Company Kit for replacing LeFebure 612 includes 1/4" x 1" x 16-1/2" bar, template, extended mount, and trim collar (6" three sides). Tools required: Hex wrench set, screwdrivers, 5/16" drill, 3/18-16 tap, welder, four clamps, two yard sticks.
- Page 3 Hamilton Safe Company Step #3: Remove the four screws that are now exposed from behind the door top channel. These may be twist off screws that will require a chisel or punch to remove or drilled completely out. Step #4: The front panel will hinge down after the four top screws are removed.
- Page 4 Hamilton Safe Company Step #5: Cut or disconnect wires going to motor. Remove three screws that hold the motor bracket to the frame and remove the motor assembly. Step #6: Cut or disconnect wires from terminal strip that lead to switch on hopper block.
- Page 5 Hamilton Safe Company Step #7: Remove the four screws holding the axle block to the right side of the housing. Step #8: Remove the eight screws holding the grout shield and remove the grout shield. Page 5 of 9...
- Page 6 Hamilton Safe Company Step #9: Remove the three screws on the top of the frame that holds the top casting to frame. Bend down the top casting to break the rear screws with a hammer and pry bar. Remove top casting from frame.
- Page 7 Hamilton Safe Company Step #11: If your template is not yet formed, bend both sides up 90 degrees and bend both tabs on the top of each side down 90 degrees. Step #12: Bolt the extended mount to the right side of the template using two 3/8" bolts.
- Page 8 Drill the three holes on the left side with 5/16" drill. These holes will need tapped 3/8-16. Step #15: The opening is ready for the new 98RH nighthead to be set in place with the template removed. Page 8 of 9...
- Page 9 Step #16: Bolt the trim collar to the new 98RH using the screws provided. Step #17: Set the new 98RH Nighthead in the housing and partially open the bucket to allow the head to be pushed into the housing flush with the wall face. From inside the safe bolt the new head into place using six 3/18-16 bolts with lock washers and flat washers.
Need help?
Do you have a question about the 98RH Nighthead and is the answer not in the manual?
Questions and answers