DUAL LITE OBN Safety Instructions

Back -lit special message sign

Advertisement

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should
READ AND FOLLOW ALL SAFETY
1. Do not let power supply cords touch hot surfaces
2. Do not use outdoors
3. Suitable for use in Damp locations
4. Do not mount near gas or electric heaters
5. Equipment should be mounted in locations and at heights where it will not
readily be subject to tampering by unauthorized personnel.
6. The use of accessory equipment not authorized by the manufacturer may cause
an unsafe condition.
7. Do not use this equipment for other than its intended purpose.
8. Servicing of this equipment should be performed by qualified service personnel.
• SEE UNIT LABEL FOR ADDITIONAL MODEL SPECIFICATIONS
• SAVE THESE INSTRUCTIONS FOR USE BY OWNER/OCCUPANT
WARNING – This product contains chemicals known to the State of California to cause cancer, birth
defects and/or other reproductive harm. Thoroughly wash hands after installing, handling, cleaning,
or otherwise touching this product.
Caution:
Wire all line conductors of the branch circuit supply through an air gap disconnect switch that
is capable of being locked in the off (open) position and is within the light of sign of any section
of the sign that is energized. The off position of the switch is to be marked "OFF" and when the
switch is actuated vertically, the down position shall be the off position.
Install on a branch circuit protected by a maximum 20A breaker.
always be followed including the following.
INSTRUCTIONS
Installer
Back -Lit Special Message Sign
OBN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OBN and is the answer not in the manual?

Questions and answers

Summary of Contents for DUAL LITE OBN

  • Page 1 Back -Lit Special Message Sign IMPORTANT SAFEGUARDS When using electrical equipment, basic safety precautions should always be followed including the following. READ AND FOLLOW ALL SAFETY INSTRUCTIONS 1. Do not let power supply cords touch hot surfaces 2. Do not use outdoors 3.
  • Page 2 INSTALLATION Note: This sign may be shipped with the housing and message panel packaged separately. Please refer to the ‘Panel addition/ Replacement’ section for steps to add the message panel to the sign housing. BACK MOUNT INSTALLATION (Fig 1.) 1. Turn OFF AC power. 2.
  • Page 3 INSTALLATION RECESSED MOUNT INSTALLATION (Fig. 3) 1. Turn OFF AC power 2. Separate the wall-mount back plate from sign housing by removing the (2) retaining screws (A) 3. Attach buckles on the backplate using the M3 screws and nuts. Also, attach the (2) guide posts to the backplate.
  • Page 4 INSTALLATION RECYCLING INFORMATION All steel, aluminum and thermoplastic parts are recyclable. All cartons contain recycled materials. Please recycle responsibly. Hubbell Lighting, Inc. Life Safety Products • dual-lite.com © 2017 Hubbell Lighting, Inc., All Rights Reserved • Specifications subject to change without notice. • Printed in U.S.A. DL_0604053_OBN_INSTR 11/17...

Table of Contents