Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Corby DP916
Summary of Contents for Corby DP916
- Page 1 W A L L / D R A W E R M O U N T E D H A I R D R Y E R www.corbyofwindsor.com...
-
Page 2: Table Of Contents
These notes must be read before use These instructions are for your safety. Please read through them thoroughly before use and retain for future reference. Failure to follow them could cause injury and/or property damage. This manual provides instructions for models with and without a shaver socket. CONTENTS SECTION 01 Cautions... -
Page 3: Cautions
CAUTIONS DO’S • Check the product and the supply cord for damage regularly. • Ensure your mains supply rating corresponds with that stated on the rating label fixed to the hair dryer before making any connections. • Always switch the product off at the base unit after use. •... -
Page 4: Important
IMPORTANT! This appliance is not intended for use by persons (including children) with reduced physical or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. -
Page 5: Identification
IDENTIFICATION Base Unit Hair Dryer FIXING PACK 1x Large Screw, 1x Small Screw, 2x Wall Plug, 1x Cap, 1x Plate TOOLS REQUIRED Power drill 6mm masonary bit Cross-head drill bit... -
Page 6: Installation (Wall-Mounted)
INSTALLATION (WALL-MOUNTED) Insert a wall plug into the Mark the wall with a pencil Use a drill and 6mm hole and secure the to indicate the location of masonary bit to drill a hole bracket as shown using a the bracket. on the marked point. -
Page 7: Installation (With Reserved Wire)
INSTALLATION (WITH RESERVED WIRE) Cable clamp Entry point Follow ‘WALL MOUNTED’ instructions numbers 1 to 6. Existing cable Terminal To remove the cover, first remove the hand piece and unscrew the two screws from the cover. Detach the cover from the base by releasing the clip, accessible through the RESERVED WIRE DIAGRAM... -
Page 8: Installation (Into Drawer)
INSTALLATION (INTO DRAWER) 50mm (minimum) Follow ‘WALL MOUNTED’ instructions numbers 1 to 7. Ensure the initial screw hole for the bracket is drilled at Substituting the drawer least 50mm from the back of the drawer to allow the base for the wall. unit to be hooked in place. -
Page 9: Plug Replacement
PLUG REPLACEMENT (for product fitted with BS plug) This appliance is NOT supplied with a plug fitted. If a plug is required, use a plug that is fitted with a 13 Amp fuse. Should the fuse require replacement, it must be replaced with a fuse rated at 13 Amp and approved to BS1362 by ASTA. -
Page 10: Specification
SPECIFICATION Rated Voltage 230V Rated Frequency 50Hz Rated Power 1200W Shaver Socket Output (max.) 230V, 1.0A (where available) 115V, 0.1A Note: The shaver socket incorporates a safety isolating transformer fitted with overload protection. This inhibits the operation of appliances with a load higher than 20VA CONFORMITY WITH DIRECTIVES Conforms with relevant European Directives... -
Page 12: Guarantee
AFFIX RECEIPT OR PROOF OF PURCHASE HERE GUARANTEE For your convenience, you are not required to complete a form and return it to us in order to validate your guarantee. However, please ensure that you retain your receipt which will act as both proof of purchase and a guarantee validation document.
Need help?
Do you have a question about the DP916 and is the answer not in the manual?
Questions and answers