Cords rated for less amperage than the appliance may overheat. Save These Instructions Technical drawing Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
3. Make sure you add 8 mm all around the case dimensions and make the cut-out in the ceiling to enable placement. Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Screws Figure 1 (Tab-Tensioned Screens Only) Magnet Trim Cover Safety Screw Trim Cover Figure 2 Figure 3 Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Page 6
Connect the various wires as shown in the diagram. Important! Only one projection screens can be connected on to one key switch. Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Page 7
Power on the motor. Press the program button twice (2x). Press the down button once (1x). Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Page 8
Two projection screens with RF remote control should not be mounted within 30 cm of each other. Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Press the program button twice (2x). RF remote control. Press the down button once (1x). Karl-Leitl-Str. 1 | 4048 Puchenau | T +43 732 70 04 25 | F +43 732 70 04 25-55 | office@hapra.at | www.hapra.at...
Page 10
Goods sold hereunder are covered by a warranty against defects in material and workmanship provided the goods and services are subject to normal use. The applicable limited warranty is two (2) years from the date the product was invoiced by Milestone. The DescenderPro range, Elpro Concept range and all electrical motors are covered by five (5) years limited warranty.