LITEWAY MidiExtender MIDI-2001 Operating Instructions

WARRANTY
All fiber optic transmission systems, products and accessories
manufactured by Liteway, Inc. and it's subsidiaries are fully tested
prior to shipment and are warranted against defective materials
and workmanship for a period of five full years from the date of the
original shipment. Should a problem occur, a Return Material
Authorization Number (RMA) must be obtained from Liteway Inc.
at (516) 931-2800 and the item returned to Liteway, Inc. 166
Haverford Road, Hicksville, NY 11801, USA, prepaid. Liteway Inc.
will then, at its option repair or replace the defective item.
Liteway, Inc. maximum liability under this warranty is limited to the
cost of the defective item only. No contingent liabilities of any kind
are either assumed or implied.
Any items returned to Liteway, Inc. that have been misused,
abused, damaged, modified, connected or adjusted in any way
contrary to the instructions furnished by Liteway, Inc. or repaired
by unauthorized personnel will not be covered by this warranty.
Any non-warranty repairs required will be quoted at the current
rate for such services.
!

Important Notices

CAUTION ! AVOID DIRECT EXPOSURE TO BEAM.
All -7,-8, and -9 Models use laser diodes. These solid-state laser diodes
are located in the optical ports of these units. Laser diodes produce
invisible radiation that may be harmful to human eyes. Never look
directly into the optical port of any fiber optic unit designed to operate
with single-mode optical fiber.
NOT FOR LIFE SUPPORT SYSTEMS
Liteway, Inc. does not authorize or warrant any of its products or
accessories for use in critical life support systems or applications of any
kind.
© Copyright 2016 Liteway, Inc. 113380 Rev C

OPERATING INSTRUCTIONS

MidiExtender®
Bi-Directional Fiber Optic
MIDI Extender
Model MIDI-2001
The MidiExtender MIDI-2001 system
consists of the two MIDI-2001
transceivers. This system will transmit all
standard MIDI 1.0 data signals over
beyond the specified 50 foot (15 meter)
limit without signal loss or interference.
Technical Specifications
Bandwidth DC – 1.0 Mb/s (Includes 31.25 Kbaud)
Protocol supported MIDI 1.0 (all formats)
Rise / Fall Time Less than 100 nanoseconds
Bit-error Rate 1 x 10-9 (worse case)
Signal Connectors 5 pin 180° DIN
Input Isolation Optical Isolation 10 KV/us
Output Drive 25mA maximum (5 times MIDI 1.0)
Operating Wavelength 850 (-1), 1300 (-3,-7), 1550 (-9)
Optical Loss Budget 0 – 10 dB
Optical Connectors Multimode (-1, -3) ST/PC, Single-mode
(-7,-9) FC/PC
Temperature Range -35º to +75ºC
Power Requirements 11-24 VAC/DC @160 mA
Physical Size (mm) 5.0"(127)L x 1.0" (25.4)W x 3.0"(7)D
All specifications measured with 1Km of 62.5u multimode fiber.
All specifications are subject to change without prior notice.