Automatic Time Setting; Button Functions; Basic Operating Functions - VocaTime Talking Atomic Dual Voice Analog Watch Instruction Manual

2

Automatic Time Setting

Your Analog talking radio controlled watch automatically receives the Atomic Clock
signal at 3:00AM every night. After reception of signal it will display the official local
time on the watch. Everything is done automatically, (unless set manually).

Button Functions:

As shown in the image above please note the following:
The S1 button is located by and is also referred to as the 2:00 Button, S2 button is located
by and is also referred to as the 4:00 button, The S3 button is located by and is also10:00
button, and the S4 button is located by and is referred to as the 8:00 button

Basic Operating functions

To hear the Time announced:
Push S1 to talk
The watch will announce the Hour and Minute
To hear the Date announced:
Push S2 once to talk
The watch will announce the Day, Month, Date and Year after a signal is updated.
NOTE: After installing a New Battery the "Day announcement" will not be activated
until it gets a first signal-see instructions below.
Dual Voice: This Talking Watch features a Dual Voice, which allows you to choose to
hear announcements in either a Male Voice or a Female voice.
TO CHANGE VOICE (switching between male and female voice):
Push and Hold S2 until new voice announces current time or calendar setting.
Reception Status Check:
1. Push S4 once while the watch is in the real-time (regular) mode
2. If the reception was successful, the watch will announce "Country Name" follow by
"Time Updated"
If the reception has failed, the watch will say "Country name" follow by "Time Not
Updated"
Alarm Setting:
1. Push S3 once
2. The watch will announce the Alarm time that has been set
3. If the Alarm is turned Off, the watch will speak "Alarm is Off"