Table of Contents
Advertisement
WSPC USER INTERFACE
Figure 3.12 Control Parameter Adjustments Display
3.8.1 Adjusting Control Parameters
Listed below are the control parameters that can be edited by the user at the
"Adjustments" display. The units and language appearing in the "Adjustments"
display correspond to the settings applied when the User Profile was created.
The WSPC must be connected to the controller (by clicking the "Connect" button)
before parameter changes are allowed.
Many changes to the control parameters at the WSPC interface will be reflected
in the WS Controller display on the compressor. However, the compressor list is
intentionally short, and limited to adjustments that might be made frequently.
When a parameter change is made at the WSPC interface, the corresponding
change appears at the controller after "Enter" is pressed on the PC keyboard or
the cursor is positioned outside of the changed field. Likewise, a change made
at the WS Controller unit causes the corresponding value to change at the
WSPC interface.
To edit a control parameter value:
1.
Select "Connect" in the Status Bar to connect communication between the
WSPC interface and the WS Controller. Connection must be enabled
before adjustments can be made at the Adjustments Display.
28
Part 1: User Level
Hide quick links:
Advertisement
Table of Contents
