Locations And Clearances - Rinnai RBBW1500 Owner And Installer Manual

Model Height
5 L 427 mm
10 L 582 mm
15 L
582 mm
25 L
582 mm
Model Plumbing access cut out C
5 L 85 x 55 mm
10 L 85 x 55 mm
15 L
85 x 55 mm
25 L
85 x 65 mm
Location and clearances
The Rinnai Boil & Brew stores and dispenses water at or close to boiling point at all times it is
switched on. Due caution must be taken when choosing a location for the product so as to
minimise misuse.
Locate the unit above a sink draining board, close to
a cold water supply and a power outlet. For the 5 L
(RBBW0500), 10 L (RBBW1000), and 15 L (RBBW1500)
models, the location of the socket outlet/plug
should be such as to give the user safe access for
turning the unit on and off. The site should be
dry and waterproof, and in a position that meets
the minimum clearances shown below. These are
required to allow safe access for servicing.
The heater should be positioned at a height to suit
the items being filled.
The Rinnai Boil & Brew must be vertically mounted.
Before installation confirm suitability of all screws and plugs for use with the wall. If unsuitable
due to the wall type provide alternative fixings.
If rear entry services are to be used the necessary holes for these should be prepared prior to
hanging the unit.
Ensure the wall can support the full weight of the unit and that there are no hidden services
(electricity, gas, or water) below the surface of the wall.
Width Depth
303 mm 154 mm
342 mm 156 mm
342 mm 210 mm
422 mm 242 mm
28 mm
49 mm
49 mm
87 mm
Depth with tap A
264 mm 124 mm
266 mm 143 mm
320 mm 143 mm
352 mm 182 mm
D E
10 mm 150 mm
10 mm 315 mm
10 mm 200 mm
10 mm 205 mm
250 mm
Rinnai Boil & Brew: Owner and installer guide: 20830-C 03-18 | 9
B
412 mm
563 mm
563 mm
563 mm
300 mm
100 mm
300-500 mm