Related Manuals for JessEm 05006
Summary of Contents for JessEm 05006
- Page 1 RETRACTABLE CASTER SET FOR JESSEM STAND #05005 Owners Manual Model #05006 61 Forest Plain Road, Oro-Medonte, Ontario, Canada, L3V 0R4 Toll Free: 1-800-436-6799 Local: 705-726-8233 Email: jessem@jessem.com Store: www.jessemdirect.com Web: www.jessem.com...
-
Page 2: Important Safety Precautions
Thank you for choosing this product from JessEm Tool Company. We appreciate your support and hope that our product serves you well. This product is designed to provide many years of reliable service provided it is used as intended and taken care of. - Page 3 PARTS INCLUDED WITH RETRACTABLE CASTER SET PARTS LIST PART # DESCRIPTION PART # DESCRIPTION 6mm Flat Washer Wheel Frame Heavy Washer Caster Wheels with Brackets M12 Nylon Lock Nut Support Plate 5mm Hex Key Foot Pedal Assembly Wrench Caster Wheel M6 x 16mm Socket Head Cap Screws...
- Page 4 Steps for the Retractable Caster Set: Model #05006 STEP 1: Remove all contents from the box. STEP 2: Ensure you have all the parts noted in the contents listed in the photo and table above. STEP 3: Adding the Caster Wheel to Foot Pedal Assembly Place the threaded end of the caster wheel through the wheel base as shown in Figure 1.
- Page 5 STEP 4: Mounting the Foot Pedal Assembly to the Wheel Frame Place the wheel frame (A) over the roller assembly as shown in Figure 4 and 5. Figure 4. Figure 5. Line the holes up on the support plate (C) with the holes in the wheel frame (A) See Figure 6. Figure 6.
- Page 6 STEP 5: Mounting the wheel frame assembly and caster wheel with brackets to stand Line up the wheel frame assembly with the 2 holes on each stand leg. Using four (4) M6 x 16mm Socket Head Cap Screws and four (4) 6mm Flat Washers, mount the wheel frame assembly and tighten the screws using the 5mm hex key provided or a 5mm T- Handle as shown in Figure 8 and 9.
- Page 7 Now that the support plate has been connected to the stand brace, tighten up the four (4) M6 x 16mm screws on the roller wheel assembly as shown in Figure 11. Figure 11. Line up one of the caster wheel and brackets to the holes on the stand leg. Using two (2) M6 x 16mm Socket Head Cap Screws and two (2) 6mm Flat Washers mount the caster wheel to the stand leg and leave screws loose as shown in Figure 12 and 13.
- Page 8 This will allow the stand to move freely when you step on the foot pedal and raise the unit off the ground as shown in the photo below. FOR MORE JESSEM PRODUCTS AND INFORMATION, PLEASE BE SURE TO CHECK OUT www.jessem.com...