MS6812
Cable Tracker User's Manual
Introduction
The Magnum Cable Tracker sends a tone down a wire to identify and
trace wires or cables bunched in a group without damaging insulation.
With this tracker, you can find and trace non-energized electrical wires,
telephone lines, data cables, alarm cables, speaker wires, coax,
thermostat wires and more.
Set includes a Sender (MS6812-T) with two alligator clips and an RJ11
plug, Receiver (MS6812-R), user manual and two 9 volt batteries.
CE
01
Functions
• Test the continuity of cables or wires
• Find a cable in a bunch without damaging insulation
• Trace the tip and ring wires in telephone lines
• Identify the status (clear, busy, ringing) of working telephone
lines
Warning
Do not use this tracker to test energized wires. Disconnect all power
before tracking wires or testing continuity. If you're not sure, consult a
qualified electrician.
Setting tone volume
Turn the dial on the Receiver to adjust tone volume
Changing tone setting
Select a dual alternating tone or a single solid tone with the switch
inside the Sender (MS6812-T)
Replacing batteries
The Sender and Receiver are battery powered. Each requires one 9
volt battery (included). To change the batteries, open the panel on the
back of either component, remove the old battery and replace it with a
new one.
Di!
Need help?
Do you have a question about the MS6812 and is the answer not in the manual?
Questions and answers