1. Manuals
  2. Brands
  3. Primary Fluid Manuals
  4. Control Unit
  5. ACCU-VENT
  6. Instruction manual

Primary Fluid ACCU-VENT Instruction Manual

Automatic degassing valve
Hide thumbs
1
2
3
4

Advertisement

Table of Contents

Please note:
This instruction manual provides detailed information and instructions that must be read, understood and
followed to ensure that the equipment is installed, operated and serviced in an appropriate manner.
Failure to do so before using may result in hazardous consequences and/or improper operation.
Temperature limit notation: If the application in which this valve is to be
installed has a temperature greater than 73°F (23°C) including radiant heat, refer
to page 4 for temperature correction Vs pressure limits.
Manufactured by:
PRIMARY FLUID
SYSTEMS INC.
ACCU-VENT
Automatic Degassing Valve
Instruction Manual
1050 Cooke Blvd., Burlington, Ontario, L7T 4A8
Tel: (905) 333-8743
www.primaryfluid.com
Call Toll Free: 1-800-776-6580
primary@primaryfluid.com
Fax: (905) 333-8746
Rev. 0
03/16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACCU-VENT and is the answer not in the manual?

Questions and answers

Summary of Contents for Primary Fluid ACCU-VENT

  • Page 1 ACCU-VENT Automatic Degassing Valve Instruction Manual Rev. 0 03/16 Please note: This instruction manual provides detailed information and instructions that must be read, understood and followed to ensure that the equipment is installed, operated and serviced in an appropriate manner.
  • Page 2 The following instructions provide information on the installation, operation and maintenance of ACCU- VENT, automatic degassing valves, manufactured by Primary Fluid Systems Inc. The valves are designed to improve the performance and safe operation of most pumps used for metering applications.
  • Page 3 Installation and Maintenance of automatic degassing valves: Automatic degassing valves are installed on the suction and/or discharge line of the pump. The valve assembly should be located at the highest point and at the first 90º turn in the line. (See Typical Installations drawing) The assembly must be kept in a vertical position to allow the valve to function properly.
  • Page 4 The installation below is a typical installation example only. Consult your engineering department for the appropriate installation for your application or call the factory for advice. Example B: System arrangement for solenoid driven (above 150 psig) or motor driven Pumps, with highly recommended flooded suction conditions. Accu-Vent Accu-pulse Top Valve, Automatic degassing valve...

Table of Contents