How To Use - HoMedics Mirra PURITY WFL-220 Manual

HOW TO USE

Instructions
1. Familiarize yourself with the pump. The switch located
at the front of the pump controls the pump speed. The
speed is indicated by a plus (+) and minus (–) sign. To
increase the speed, move the switch slowly to the left
in the direction of the plus sign. At its highest speed
level, the switch will cease to move any farther. To
decrease the pump speed for less water flow, move
the switch to the right toward the minus sign. Similarly,
at its lowest speed, the switch will cease to move any
farther.
2. Clip the LED light into the plastic ring located inside
the lid, then place the fountain top on the lid and
twist clockwise to lock into place.
3. Connect the tube from the fountain top to the pump.
4. Fill the base with water up to the fill line. Keep the
water filled to the suggested level at all times for
optimum performance.
5. Set the connected fountain top and lid on the base.
6. Starting with the largest piece, place slate pieces
onto the fountain top.
7. Rinse the rocks with water. Arrange the rocks on
the platform.
8. Attach the AC adapter jack to the base power cord.
DO NOT plug into an outlet at this time.
9. Set the fountain on a level, waterproof surface.
10. Plug the cord into a 120-volt household outlet and
power on using the switch located on the power
cord.
NOTE: Ensure that the electrical cord loops below the
electrical outlet to form a "drip loop." This will prevent
water from running down the cord into the electrical
outlet.
11. For the best results, operate with the pump completely
submerged. Keep the water level at the fill line at all
times.
TO CLEAN
1. To clean the pump: Unplug from the electrical outlet.
Use a small brush or stream of water to remove any
debris.
2. To keep water clean: Periodically change the
water and clean the product according to the
water condition. Over time, fountain water and the
fountain itself become dirty. We suggest cleaning
and exchanging water weekly to increase the
longevity of the fountain.
3. To clean off hard water deposits on the base: Soak
the base in a mixture of vinegar and water to clean
and remove any mineral buildup.
4. Keep water at an optimum level: Add water
periodically to keep it at an optimum level to avoid
shortening the life of the pump. Never let the pump
run dry.
5. Fountain storage: Unplug the fountain from the
electrical outlet, empty the water, dry the fountain,
and store rocks and fountain in a cool, dry place.
www.homedics.com US: 1-800-466-3342 CAN: 1-888-225-7378 IB-WFL220