Table of Contents
Advertisement
Quick Links
TM
TM
LIGHTING
INSTALLATION & MAINTENANCE
INSTRUCTIONS ON THE
PCR-5
4 CHANNEL
REMOTE CONTROL SYSTEM
FEATURES
Easy to Install
Approved to UL1563 & CSA C22.2 No. 218-1-13
Pending
Remote Control Operation from PCT-5
Transmitter
Optional Local Control from BR-04 Module
Optional Wi-Fi Control from Apple iOS Devices
or Android Devices
IP65 Wet Location Construction
PENDING
BELLSON ELECTRIC PTY LTD
1/3 CAPTAIN COOK DRIVE CARINGBAH NSW 2229
PHONE: (02) 9531 1555
www.bellson.com.au
P.O. BOX 2966 TAREN POINT NSW 2229
FAX: (02) 9531 2666
Advertisement
Table of Contents
Summary of Contents for BELLSON ELECTRIC PAL Touch-5 Series
-
Page 1: Remote Control System
Optional Local Control from BR-04 Module Optional Wi-Fi Control from Apple iOS Devices or Android Devices IP65 Wet Location Construction PENDING BELLSON ELECTRIC PTY LTD 1/3 CAPTAIN COOK DRIVE CARINGBAH NSW 2229 PHONE: (02) 9531 1555 www.bellson.com.au P.O. BOX 2966 TAREN POINT NSW 2229... - Page 2 INSTALLATION INSTRUCTIONS FOR PCR-5 4 CHANNEL REMOTE CONTROL SYSTEM The PCR-5 4 Channel Remote Control System only works as a system with the PCR-4 or PCR-200 PAL Colour Touch Drivers. As shown in the illustration below the system is controlled by TOUCH from the PCT-5 Transmitter or by optional Wi-Fi Control from Android or Apple Smart Phones and Tablets.
- Page 3 IMPORTANT INFORMATION The PCR-5 must be installed in accordance with the National Electrical Code by a Certified Electrician or Qualified Pool Technician. INSTALLATION INSTRUCTIONS FOR PCR-5 RGB OUTDOOR CONTROLLER Step 1. The PCR-5 Enclosure must be located a minimum distance of 5 feet measured horizontally from the inside wall of the pool and not less than 1 foot above the maximum pool water level measured to the top of the PCR-5 Enclosure.
- Page 4 INSTALLATION INSTRUCTIONS FOR PCR-5 RGB OUTDOOR CONTROLLER Note: Use the 4x Mounting Feet to fasten the enclosure to the wall with the screw set supplied. Power On 1/2” PVC Conduit Adaptor ELECTRONIC 1/2" PVC POWER SUPPLY Power Conduit 100 - 240 AC/12V DC Supply &...
- Page 5 CABLE CONNECTION DETAILS FOR CHANNEL 1, 2 & 3 FROM FROM FROM SUPPLY SUPPLY SUPPLY N/L2 N/L2 N/L2 L1 N/L2 L1 N/L2 L1 N/L2 TO CH1 TO CH2 TO CH3 LOAD LOAD LOAD CABLE CONNECTION DETAILS FOR CHANNEL 4 FOR 120V 2 SPEED MOTOR CH4A COM Low High...
-
Page 6: Time Setting
TIMER INSTRUCTIONS TIME SETTING To set the current time turn the minute Hand clockwise. Do not set the time by Rotating the “outer” dial. Turn the minute hand clockwise until the time of day on the outer dial is aligned with the triangle marker on the inner dial (two o’clock position). - Page 7 DIMENSIONAL DETAILS 7 1/8” / 181.0mm 6 7/8” / 174.0mm IP65 13/16” / 21.0mm Knockout to connect power supply All PCR-5 remotes are supplied with 1x PCT-5 Hand Held Transmitter & Wall Holder 13/16” / 21.0mm Knockout is fitted on the bottom of both sides of the enclosure 13/16”...
Need help?
Do you have a question about the PAL Touch-5 Series and is the answer not in the manual?
Questions and answers