Summary of Contents for Forest-Master Bulk Log Stand 2
- Page 1 BULK LOG STAND 2 Patent Pending Safe, Secure, Multiple Log Sawhorse IMPORTANT: Read this manual fully before assembly and use and observe all safety rules and operating instructions...
- Page 2 Parts List Assembly Operation Safety Warranty Maximum total weight of logs 150 kg Length 640 mm Width 590 mm Height (stored) 690 mm Minimum working height 720 mm Maximum working height 1300 mm Weight 8.2 kg Bulk Log Stand 2...
- Page 3 Bulk Log Stand 2...
- Page 4 Insert the bolt tubes (8) into the outermost holes in the wood base (9). The tubes should be inserted from the side with only 2 holes visible, until approximately 28 - 29 mm of tube is still protruding. Bulk Log Stand 2...
- Page 5 (4) and small washer (6). Ensure that the bolt is tight before proceeding to step 3. STEP 3: Using a M8 x 45mm bolt (4) and a large washer (5), secure the bolt tube to the wood base. Bulk Log Stand 2...
- Page 6 M8 x 45 bolt and large washer. STEP 5: Insert a U-Support (3) into one of the holes in the top of the wood base. Ensure the locating tube is fully seated in the hole. Repeat for the second U-Support. Bulk Log Stand 2...
- Page 7 STEP 6: Insert a telescopic upright (2) into one of the guide tubes of a U-Support and secure with a thumbscrew (10). Repeat for the remaining telescopic tubes. Bulk Log Stand 2...
- Page 8 STEP 2: Load the logs into the U-Supports so that the overhangs outside of the U-Supports are roughly equal. Ensure you do not exceed the maximum total weight of logs given on page 2. Bulk Log Stand 2...
- Page 9 U-Supports. If the overhanging ends need to be cut into multiple logs then cut alternately from each end in order to keep the weight over the centre of the stand. Bulk Log Stand 2...
- Page 10 & cautions. Use the product correctly and with care for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Please keep these instruc- tions safe for future use. Bulk Log Stand 2...
-
Page 11: Important Safety Information
IMPORTANT: Check that the logs are secure and the log stand is stable before beginning to cut. WARNING: Do not exceed the specified maximum total log weight as given on page 2 of this manual. Bulk Log Stand 2... - Page 12 Manufactured under license for Forest Master Limited. Head Office: Forest Master Ltd, Industry Road, Heaton, Newcastle Upon Tyne, NE6 5XB, United Kingdom. Tel: +44 191 2966939 email: info@forest-master.com - web: www.forest-master.com...