Wixey WR510 Type 2 Instructions Manual

Planer readout

Advertisement

Quick Links

Wixey
PLANER READOUT
MODEL WR510 Type 2
INSTRUCTIONS
If your planer has preset depth stops, lower the cutter head until it contacts any one of the stops. If it does not
have a preset stop, lower it as low as it will go which is usually 1/8".
Most models will refer to FIG 1. For the Dewalt model DW735 refer to FIG 2 and for the Delta model 22-580
refer to both FIG 3 and FIG 4.
FIG 1
NOTICE
Always turn off the power and unplug your
:
machine before installing the Planer Readout on it.

1- Prepare your Planer

FIG 3
1
FIG 4
FIG 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WR510 Type 2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Wixey WR510 Type 2

  • Page 1 Wixey machine before installing the Planer Readout on it. PLANER READOUT MODEL WR510 Type 2 INSTRUCTIONS 1- Prepare your Planer If your planer has preset depth stops, lower the cutter head until it contacts any one of the stops. If it does not have a preset stop, lower it as low as it will go which is usually 1/8”.
  • Page 2 2- Position the Readout assembly Although the WR510 Planer Readout will function properly mounted many ways, it is recommended that the foot of the frame is mounted level to or slightly above the surface of the planer table of your planer ( FIG 5 and FIG 6).
  • Page 3 FIG 9 FIG 10 3- Attach the Readout assembly to your Planer Peel the paper backing from the foam tape and attach the Readout assembly to your planer as shown in FIG 11. If you are using a leveling screw the high strength foam tape will secure your Readout assembly indefinitely. For installations that do not use the leveling screw such as the Dewalt model DW735 and for a more secure mounting you can permanently attach the assembly using thread forming screws as shown in FIG 12.
  • Page 4 4- Attach the mounting bracket to your Planer For most models you can attach the mounting bracket where the original pointer was located using the original screws as shown in FIG 13. If this is not possible or the original pointer location does not locate the mounting bracket in the proper position refer to FIG 14.
  • Page 5 5- Adjust the Readout Adjust the position of the readout as shown in FIG 17 and FIG 18. FIG 17 FIG 18 Note: If the scale does not slide freely after following the steps in FIG 18, refer to Trouble shooting in section 6- Readout operation...
  • Page 6 7-Calibration 8- Measuring a board...
  • Page 7 9-removing a precise amount of material 10- Trouble shooting Problem Possible Cause Solution Flashing Digits Low Voltage Replace Batteries No Display Low Voltage Replace Batteries No Display Bad Contact Clean Batteries Erratic or Frozen Display Internal Error Remove Batteries, Wait 1 Minute and Replace...
  • Page 8 For questions, comments, and application examples go to: www.wixey.com...

Table of Contents