Table of Contents
Advertisement
Advertisement
Table of Contents
Summary of Contents for Cater-Wash Jolly Series
- Page 1 - 1 -...
- Page 2 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER INSTRUCTION MANUAL – FOR INSTALLER - ENGLISH - INDUSTRIAL GLASS AND DISHWASHER, UNDERCOUNTER FOR EXCLUSIVE USE OF TECHNICALLY QUALIFIED PERSONNEL Attention: READ THESE INSTRUCTIONS CAREFULLY BEFORE PROCEEDING WITH THE INSTALLATION AND OPERATION OF THE MACHINE. ANY INSTALLATION, ALTERATION, OR MODIFICATION THAT DOES NOT MEET THE STANDARDS IN THIS MANUAL MAY CAUSE A MALFUNCTION OR DAMAGE TO THE MACHINE.
-
Page 3: General Information
INSTRUCTION MANUAL INDUSTRIAL DISHWASHER GENERAL INFORMATION This dishwasher is in compliance with the provisions currently in force concerning safety. Improper use can cause damage to people and / or property. Before starting the machine, read these instructions containing important information about installation and safety. - Page 4 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER INSTALLATION AND START UP The installation of the machine must be carried out only by qualified technical personnel, in accordance with these instructions and in compliance with the regulations. ¨ Remove the packing and the polystyrene from the machine, and check for damage. If damaged they must be notified in writing to the carrier.
- Page 5 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER ATTENTION! The dishwasher can be connected to the cold water system (minimum temperature + 5 ° C) or to the hot water system (maximum temperature +50 ° C) with appropriate loading pipe to the standard EN 61770. For connection to the water mains use only new hoses.
-
Page 6: Electrical Connection
INSTRUCTION MANUAL INDUSTRIAL DISHWASHER ELECTRICAL CONNECTION ATTENTION The electrical connection of the machine and any additional equipment should be undertaken by licensed and qualified electricians. ¨ The machine must be serviced with the values of power, voltage, frequency and protection as specified on the name plate. -
Page 7: Control Panel
INSTRUCTION MANUAL INDUSTRIAL DISHWASHER CONTROL PANEL - 7 -... - Page 8 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER DESCRIPTION N° ON/OFF SWITCH ON/OFF LIGHT CYCLE BUTTON CYCLE LIGHT COLD RINSE BUTTON COLD RINSE LIGHT DRAIN BUTTON DRAIN LIGHT WATER SOFTENER REGENERATION BUTTON WATER SOFTENER REGENERATION LIGHT TIME SELECTION TIME SELECTION LIGHT LIGHT—RINSE BOILER ELEMENT LIGHT—WASH TANK ELEMENT - 8 -...
- Page 9 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER OPERATION ATTENTION The initial operation of the dishwasher MUST be performed by authorized and qualified personnel who will also follow instructions relating to the operation. ¨ Open the water supply and switch on the electrical supply. ¨...
- Page 10 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER ADJUSTING CHEMICAL DOSING ATTENTION It is important to observe safety regulations in the use of corrosive products. We recommend the use of gloves and gog- gles. RINSE AID DISPENSER—HYDRAULIC PUMP ¨ Remove the front panel by loosening the screws. This will access the dispenser. ¨...
- Page 11 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER RINSE AID DOSING BY PERISTALTIC PUMP (OPTIONAL) ¨ Remove the front panel of the machine by removing the screws. This will access the dispenser. ¨ Mount the filter on the end of the pick-up tube and place it in the rinse aid bottle. ¨...
- Page 12 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER DETERGENT DOSING BY PERISTALTIC PUMP (OPTIONAL - ONLY ON SOME VERSIONS) ¨ Mount the filter on the end of the pick-up tube and place it in the detergent bottle. ¨ The detergent dispenser works during the filling and rinsing at the end of the wash cycle. To start, perform a series of washes and check the soil removal on the dishes.
-
Page 13: Troubleshooting
INSTRUCTION MANUAL INDUSTRIAL DISHWASHER TROUBLESHOOTING PROBLEM REMEDY 1) Make sure the electrical power is “ON” at the isolator. 2) Check that power is on at the On/Off switch. The machine will not start 3) Check that the door is closed properly and that the switch is working. 4) Check the water level in the wash tank and the fill solenoid valve. - Page 14 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER REMEDY PROBLEM 1) Use only defoamed detergent and rinse aid. The water supply to the machine must be soft or demineralised. Glassware does not sparkle 2) Too much detergent, or too much rinse aid may be used. 1) Verify that the water temperature in the wash tank is not less than 50 °...
- Page 15 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER - 15 -...
- Page 16 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER - 16 -...
- Page 17 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER CARD ST - 17 -...
- Page 18 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER DEEP POSITION CARD ST - 18 -...
- Page 19 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER CARD EVO - 19 -...
- Page 20 INSTRUCTION MANUAL INDUSTRIAL DISHWASHER DEEP POSITION CARD EVO ATTENTION In case the Electronic Card should be replaced, remember to set the Deep Switch exactly the same way of the previous card. . - 20 -...
- Page 21 LAVABICCHIERI/LAVASTOVIGLIE INDUSTRIALE - LIBRETTO ISTRUZIONI - INSTALLATORE LIBR_A_01/12 - 21 -...
Need help?
Do you have a question about the Jolly Series and is the answer not in the manual?
Questions and answers