Table of Contents
Advertisement
Quick Links
Mounting Bracket Lock Installation
The mounting bracket locks will give you peace of mind, deterring anyone from taking the Skycamp
off your vehicle. One lock goes on each crossbar, and the locks block access to the nuts.
Please follow these instructions for an optimal installation.
Included parts:
-
2 bracket locks (1 top and 1 bottom piece each)
-
2 keys
-
8 rubber pads
Advertisement
Table of Contents
Summary of Contents for iKAMPER Mounting Bracket Lock
- Page 1 Mounting Bracket Lock Installation The mounting bracket locks will give you peace of mind, deterring anyone from taking the Skycamp off your vehicle. One lock goes on each crossbar, and the locks block access to the nuts. Please follow these instructions for an optimal installation.
- Page 2 STEP 1 Step 1: When using the mounting bracket locks, the 2 bolt can be used in holes 3 and 4 only. Place the second bold in one of these two holes, closest to your crossbar. STEP 2 Step 2: Slide the top bracket into the rail under the Skycamp, so that one bolt is on each side of the crossbar.
- Page 3 STEP 3 Step 3: Take the top piece of the mounting bracket lock and place it over the bolts. NOTE: this piece replaces the standard bottom bracket piece. STEP 4 Step 4: Tighten the nuts, on one bolt, then the other, going back and forth. NOTE: apply lubricant to...
- Page 4 STEP 5 Step 5: Place 1-2 rubber pads between the Skycamp rail and lock before completely tightening the nuts. STEP 6 Step 6: Once the nuts are securely tightened, place the bottom piece of the mounting bracket locks over the nuts and secure in place by twisting the locks on each side.
- Page 5 STEP 7 Step 7: Twist the hand-tightening nut to insure the bottom bracket piece is tight. STEP 8 Step 8: One crossbar done! Now repeat the process with the second lock on your other crossbar.
Need help?
Do you have a question about the Mounting Bracket Lock and is the answer not in the manual?
Questions and answers