Advertisement
Quick Links
This is a safety alert symbol and should never be ignored. When you see this symbol on labels or in
manuals, be alert to the potential for personal injury or death.
Improper installation, adjustment, alteration, service
or maintenance can cause property damage, personal
injury or loss of life. Installation and service must be
performed by a licensed professional installer (or
equivalent), service agency or the gas supplier.
For your safety, do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any
other appliance. Such actions could result in property
damage, personal injury, or death.
These units are not approved for mobile home
applications. Such use could result in property damage,
personal injury, or death.
Manufactured By
Allied Air Enterprises LLC
A Lennox International, Inc. Company
215 Metropolitan Drive
West Columbia, SC 29170
507390-01
INSTALLATION INSTRUCTIONS
EWC V-Series
This manual must be left with the homeowner for future reference.
WARNING
WARNING
WARNING
Save these instructions for future reference
Models
TM
Installation and servicing of air conditioning equipment
can be hazardous due to internal refrigerant pressure
and live electrical components. Only trained and
qualified service personnel should install or service
this equipment. Installation and service performed by
unqualified persons can result in property damage,
personal injury or death.
Installation shall be made in accordance with the
requirements of the local utility and other authorities
having jurisdiction, or with the National Fuel Gas
Code, ANSI Z223.1 (latest edition) and the National
Electrical Code. Any alteration of internal wiring will void
certification and warranties.
*P507390-01*
Issue 1733
WARNING
CAUTION
(P) 507390-01
Page 1 of 5
Advertisement
Related Manuals for Magic-Pak EWC V Series
Summary of Contents for Magic-Pak EWC V Series
- Page 1 INSTALLATION INSTRUCTIONS EWC V-Series Models This manual must be left with the homeowner for future reference. This is a safety alert symbol and should never be ignored. When you see this symbol on labels or in manuals, be alert to the potential for personal injury or death. WARNING WARNING Improper installation, adjustment, alteration, service...
-
Page 2: Installation
NOTE: Be sure to remove the chassis hold down brackets Installation from the outdoor side of unit before installation. These brackets are located below the louver panels. Installation shall be made in accordance with local utility requirements and any other authorities having jurisdiction. Location The unit is approved for indoor installation only. -
Page 3: Condensate Drain
Installing without a Wall Sleeve Be certain that the plastic drain tube has free drainage and is not crimped or flattened at any bend. Provide an opening in an outside wall with minimum dimensions 28” side and 43-1/4” high (see Figure 1). Local Test drainage by pouring water into the drain pan under the ordinances may require a steel lintel to support the wall evaporator and see that it is removed rapidly through the... -
Page 4: Operation
Air Filter Adjustments All indoor return air must be filtered before it passes through No adjustments are required or should be attempted the evaporator coil. A permanent-type filter is furnished regarding any of the components of the cooling chassis with the unit, located directly in front of evaporator coil. and electric heating section. -
Page 5: Heating Section
Maintenance Cooling Chassis The refrigeration system contained in the cooling chassis normally requires no maintenance since it is a closed self- contained system. Periodic maintenance is limited to: Cooling Chassis is charged with R410A refrigerant. • Cleaning the evaporator air filter. Follow the directions noted on the filter and label attached to the access panel.