Gandy Orbit-Air 62DS12F Parts List, Instructions

10 Cu. Ft. (.28m
The Following Parts Are Shipped Inside Hopper:
1 ....................... Packet Containing ................Parts & Packing List, Operator's Manual, Rate Chart & Ag Warranty
2 ....................... L04-0005-000 ......................Cable Tie (5/16 x 15-1/4)
1 ....................... M10-0005-004 .....................Manual Holder
1 ....................... 0197102-1 ............................Manual Bracket Holder
1 ....................... 6212-D .................................Air Pressure Gauge Carton (See Page for Contents)
1 ....................... 629068-A .............................Parts Carton Containing: (See Page for Contents)
Maintenance
Check all bolts for tightness after first two hours of use; check periodically thereafter.
Grease all fittings regularly.
There are Three grease fittings on hopper. These must be greased before use and periodically during use.
Locations: See page 7.
One grease fitting on each 1-inch bearing (D05-1000-010) (Two) located on the 1-inch drive shafts (628720-13).
One grease fitting on drive shaft housing (62853-15) located under Speed control (G06-0060-000).
Lucubrate chains as needed.
Periodically clean intake screen on hydraulic driven blower.
Orbit-Air
Implement Mounted Hopper
3
) Hopper, 450-Lb Chemical Capacity
w/ 12 (1-1/4") Outlets, Fertilizer (F) Red Wheels
For Use w/ 1-1/4 I.D. Tubing
Single Metering Shaft, No Clutch
12-Volt Electric Motor Driven
(All Parts & Hardware in Place Unless Otherwise Specified)
Parts List & Instructions
815 Rice Lake Street, Owatonna, MN 55060
Phone: 800-443-2476 / 507-451-5430
www.gandy.net / Email: sales@gandy.net
62DS12F
®
Applicator
Page 1 of 17