Monoprice 38169 Quick Install Manual

120-Watt Slider Resistance Speaker Volume Control

INTRODUCTION

This 120-Watt Speaker Volume Control features audiophile sound quality, with virtually no
high-end or low-end roll-off. It has a non-shorting design, which prevents amplifier
damage, and color-coded, right-angle, solderless speaker terminals with easy top
termination. It uses a 12-position switch, which offers a total of 36dB attenuation, with Off,
two 6dB, seven 3dB, and full on settings. The package includes white, almond, and ivory
plastic inserts and knobs.

INSTALLATION

Perform the following steps to install this volume control to your stereo system. These
instructions assume that you have already installed the speaker pair and low-voltage
mounting bracket at the desired locations.
1. Ensure that the amplifier is turned off and unplugged from its power source.
2. Run an in-wall rated speaker wire from the left-channel speaker to the low-voltage
mounting bracket.
3. Connect the wire to the left channel speaker, taking note of the wire colors or
markings used for the positive (+) and negative (-) connections.
For best results, always use the same wire colors or markings for the positive and negative
connections.
P/N 38169
Quick Install Guide
1