Advertisement
Filling the tank with water
Open the lid of the water tank, holding it by hand,
pour distilled water using a measuring glass.
Pour water in the mop to the mark «MAX», close
the water tank with a special lid.
Caution: The capacity of the water tank is 230
ml.
Make sure that the water, you want to fill the
tank, is clear and free of impurities, otherwise the
device may break down.
Switching on/spraying
Remote control of mop operation and water
spraying.
In standby mode, press the power button, after
which the mop will turn on and begin to perform
reciprocating movements. Press the button again
to turn off the device. Periodically press and hold
the spray button to spray water.
Release the spray button to stop spraying the water.
Caution: when the battery level is low, the remote control function does not work
The maximum possible holding time of the injection button is 5 seconds
For normal response with remote control, the intervals between each push of a button
should be longer than 1 s.
Charge level indicator
Each of the three indicators of the charge level
corresponds to a certain percentage of the
charge level - 100%, 65% and 30%. When all
three indicators blink, the charge level is low.
Using
Spray button
On/Off button
Charge level
indicators
3 indicators - 100%;
2 indicators - 65%;
1 indicator - 30%;
3 flashing lights - low charge.
Remove the rubber plug from the port to recharge the
device, plug the power adapter into the appropriate
connector.
Attention: use the original power adapter.
Step by foot on a special mark on the fabric head, lift the
device to separate it from the mop.
Precautionary measures
The mop can be automatically locked if the device is turned off and the handle is in a level
vertical position.
After repeated use on textile velcro, there may be a lot of different foreign objects, dust,
which reduces the effectiveness of its stickiness. Please use a soft brush to periodically
clean a velcro from foreign objects.
After each use, remove, wash and dry the fabric head or use disposable fabric head.
Disposable fabric heads are made of environmentally friendly material, with repeated use
their effectiveness is reduced.
In the water tank it is necessary to add distilled water without impurities. After using the
mop, you need to drain the rest of the water. If special essential oils are added, rinse the
water tank several times after use.
Using
Charge levels of the device
First charging
Changing a head
Handle
Textile velcro
Fabric head
Water Tank
Advertisement
