Subscribe to Our Youtube Channel
Summary of Contents for Thermon Terminator ZL
- Page 1 Terminator Lighted Power Connection/ End Termination Kit INSTALLATION PROCEDURES For Power Connection or End Termination Applications...
- Page 2 • Component approvals and performance ratings are based on Terminal Blocks with DIN Rail the use of Thermon specified parts only. User supplied power (Refer to terminal specifications for maximum connection fittings must be listed or certified for intended use.
- Page 3 Terminator INSTALLATION PROCEDURES Locate bus connection (HPT and FP only) and Insert cable into expediter. If mounted on Slide expediter toward pipe and route cable cable as shown. Cut end of cable at angle to aid bottom or side of pipe, punch out weep hole. through support base entry.
- Page 4 Power Connection (1 to 2 Heating Cables) End Termination (1 Heating Cable Only) Corporate Headquarters: 100 Thermon Dr • PO Box 609 San Marcos, TX 78667-0609 • Phone: 512-396-5801 • 1-800-820-4328 For the Thermon office nearest you visit us at . . . www.thermon.com Form PN50848-0519 ©...
Need help?
Do you have a question about the Terminator ZL and is the answer not in the manual?
Questions and answers