Wiring Instructions - Vetus-Maxwell RC12-HD Manual

8. Assemble the lower clutch cone making sure it sits nicely on the retaining clips. Apply lithium based marine
grease generously to the conical surface of the clutch cone, to assist with free falling the anchor.
9. Put the Belleville washer on top of the lower clutch cone and install the chainwheel assembly. Put the other
Belleville washer on top of chainwheel assembly.
10. Insert key on mainshaft and install upper clutch cone, after applying marine grease to its conical surface
11. Insert key on mainshaft, assemble drum and washer (Capstan models only).
12. Assemble clutch nut .
13. Put retaining washer on top of the mainshaft and secure it with the screw.
14. Insert the cap into the clutch nut.
2.4

WIRING INSTRUCTIONS

Installation must be carried out in accordance with USCG, ABYC, NMMA or other relevant local electrical
requirements.
We recommend that connection of the power lines and control circuitry to the windlass be done by qualified
technicians, to ensure reliable and safe operation of the windlass.
After all connections have been made and system tested, seal terminals against moisture by spraying with:
CRC2043 "Plasti-Coat", CRC3013 "Soft Seal" or CRC2049 "Clear Urethane".
Solenoid pack (Required)
The solenoid pack (B) should be located in a dry area close to the windlass, not in the rope/chain locker.
Circuit breaker/isolator (Required)
! FOR SAFETY - The winch circuit requires
either a fuse or circuit breaker, rated as follows:
RC12-HD 24V : 135amp
Position the circuit breaker/isolator (C) no further than 1.8 m (6 ft) away from the battery (D) in an
accessible and dry location.
Remote control panel (Recommended)
The remote control panel (E) should be mounted in a convenient location (such as the bridge, helm or
cockpit) so that the operator can see the windlass.
Footswitch (Optional).
For safe operation, the footswitch (F) should be approximately 500 mm (20") from the windlass (A).
The below-deck part of the footswitch must be in a dry environment and the breather holes must be kept
clear.
The arrows on the footswitch should be arranged to indicate the direction of operation.
Fit the switch according to the instructions supplied. Connect wiring as shown.
6
protection provided by an isolator switch and
www.maxwellmarine.com