Advertisement
SHAVING
Note: this product is for corded use only.
1.
Connect the shaver to the power cord and then to the mains.
2.
Slide the power switch to turn on.
3.
Stretch the skin with your free hand so the hairs stand upright.
4.
Only apply light pressure on the shaving head while shaving (pressing too hard can
damage the heads and make them vulnerable to breakage).
5.
Use short, circular strokes.
TRIMMING
1.
Slide the trimmer button to release the detail trimmer.
2.
Hold the trimmer at a right angle to your skin.
3.
Place the trimmer at desired trim line for a quick, easy professional trim.
4.
To retract the trimmer, push down until it locks into position.
TIPS FOR BEST RESULTS
•
Ensure your skin is dry. Always hold the shaver at right angles to the skin so that all
three heads are touching the skin with equal pressure.
•
Use moderate to slow stroking movements. The use of short circular motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
•
DO NOT press hard against the skin in order to avoid damage to the rotary heads.
CARE FOR YOUR SHAVER
Care for your appliance to ensure a long lasting performance. We recommend you clean
your appliance after each use.
•
Ensure the appliance is switched off and unplugged from the mains before
cleaning.
1.
Open the shaver head by pressing the release button (Fig. A).
2.
Empty out any hair clippings.
3.
Pull the shaver head upwards to remove it from the body (Fig. B).
4.
Locate the centre arrow and slide the retainer in the opposite direction to release it.
Once released, lift it out of the shaver head (Fig. C). Make a note of the correct
orientation of the retainer to make refitting easier.
5.
Carefully brush away any hairs from the cutters.
6.
For a more thorough cleaning, lift out the three cutters (Fig. D).
7.
Wash the shaving head unter running water (Fig. E). Allow to dry thoroughly.
8.
Carefully refit the three cutters.
9.
Refit the retainer. Locate the centre arrow and slide the retainer in the same
direction as the arrow until it clicks into place (Fig. F).
5
Advertisement
