Tumble Dry; To Rinse, Spin And Tumble-Dry - Splendide WD802M Owner's Manual

Combination washer & vented dryer
Hide thumbs Also See for WD802M:
Table of Contents

Advertisement

HOW TO USE YOUR NEW WASHER-DRYER
• Load the drum with clothes as previously described.
Close the door.
• Select a program. See chart below.
• Select drying time (and half heat if required).
• Select desired spin speed (high spin only occurs in
regular wash cycle).
• Put the detergent, bleach and fabric conditioner into
the dispenser.
• Press the ON-OFF button to start the machine.
Note: Woolen garments should under no circumstances
be tumble dried.
TUMBLE-DRY
If you want to tumble dry a load without washing, rinsing
or spinning, proceed as follows:
Note: The dry weight of the load must not exceed
requirements previously mentioned.
• Make sure that the power cord is plugged in and that
circuit is energized.
• Make sure that the wash timer knob is at an OFF-DRY
position.
• Press the Half Heat button, if you wish to dry at a low
temperature.
• Set the Dryer Timer knob to the drying time you
require.
**Compartments may be used with the selections
indicated.
*With the cycle C/C please proceed as follows.
COLD WASH
Add detergent in compartment "A"
• Open the door, load the articles to be dried into the
cylinder and close the door.
• Press the ON/OFF button in and the machine will then
start the drying cycle.
• Door may be opened during drying cycle.

TO RINSE, SPIN AND TUMBLE-DRY

It is possible to rinse, spin and tumble-dry articles which
have not been previously washed in the machine. The dry
weight of the load must not exceed load size previously
described.
• Make sure that the power cord is plugged in and that
the circuit is energized.
• Open the hot and cold water taps fully.
• Load the machine with the articles to be rinsed.
• If you wish, put fabric conditioner in the additives
compartment "D" of the Detergent Dispenser.
• Turn the program selector knob to the position marked
"Rinse". Select the desired heat setting. Press the half
heat if you want a low dry temperature. Set the dryer
timer to the desired time.
• Select the desired spin speed. High speed spin only
occurs in the regular cycle.
Switch the machine on by pressing the ON/OFF
button.
WASHING TABLE
PRE-WASH/COLD WASH
Add detergent in compartment "A" and Switch the
machine on.
When the machine starts the pre-wash, open the
detergent dispenser drawer and add further detergent
to compartment "A" for the REGULAR wash cycle.
Page 10

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents