Listening To The Radio - HoMedics SoundSpa Fusion SS-6510B-AV Instruction Manual And Warranty Information

Listening to a non-docking iPod or other portable
audio devices
If you are using an iPod without a
docking port, other MP3 player, or
other portable audio device, you can
play it through the SoundSpa Fusion
via the LINE IN located on the back
of the unit (Fig. 9).
1. Plug one end of the Connection
Cable (included) into the
headphone or line-out jack on your
audio device and the other end of the Connection Cable into
the SoundSpa Fusion LINE IN, located on the back of the unit.
2. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
3. Toggle through the AUDIO BUTTON on the unit until you reach the
auxiliary mode. The AUX ICON (Fig 2) will appear in the right side of
the clock, to indicate that the auxiliary mode has been selected.
4. Turn on and play external audio device.
5. Turn on VOLUME KNOB (Fig 1) on the unit to adjust the system
volume. Note: You may need to adjust the volume on external
device also.
6. To turn off the unit, press the POWER BUTTON on the top of the unit.
Note: You may need to turn off your external audio device as
well.
Listening to Nature Sounds
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Select the Sounds button to toggle through the different nature sounds
Figure 9
10
(Fig 1). They will be shown on the bottom of the LCD display, below the
time. (Fig. 2)
3. Turn the VOLUME KNOB on the unit to adjust the volume (Fig. 1).
4. To turn off the nature sounds, press the POWER BUTTON to turn the unit
off, or switch the audio mode by pressing the AUDIO BUTTON (Fig. 1).
Note: When the unit is turned on, it will always default to the last
mode used.

Listening to the Radio

FM Antenna
Extend FM wire antenna fully for best FM
reception (do not strip, alter or attach to
other antennas).
AM Antenna
Snap the AM loop antenna into the base
provided. Next, plug the AM loop antenna
into the connector located on the back of
the unit for best AM reception (Fig. 10).
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Toggle through the AUDIO BUTTON to play the radio (Fig. 1). The
RADIO ICON will appear on the right side of the clock (Fig. 2).
3. To choose between FM or AM radio, press the AUDIO BUTTON again.
The FM or AM icon will show on the left side of the clock to indicate the
band that is selected (Fig. 2).
4. Turn the SET +/- knob on the unit to tune in the desired station (Fig. 1).
5. Turn the VOLUME KNOB on the unit to adjust the system volume (Fig. 1).
6. To turn off the unit, press the POWER BUTTON.
Figure 10
1 1