Advertisement

Quick Links

SW2010PHR Washer
User Manual
spraywash215x75.pdf 1 21/08/2018 09:03:20
C
M
Y
CM
MY
CY
CMY
K
Product id & serial number information
793-1206

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Spray Wash SW2010PHR and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dual Pumps Spray Wash SW2010PHR

  • Page 1 793-1206 SW2010PHR Washer User Manual spraywash215x75.pdf 1 21/08/2018 09:03:20 Product id & serial number information...
  • Page 2: Table Of Contents

    SW Series Washer User Manual This manual and any other literature supplied should be read thoroughly before assembling and operating the Washer. Pay particular attention to any instructions relating to safety, and the starting, stopping and maintenance of the Washer. Following these instructions will ensure operator safety and prolong the life of the Washer.
  • Page 3: Environmental Protection

    1. Environmental Protection The packaging material Old appliances contain valuable materials can be recycled. Please do that can be recycled; these should be sent not throw the packaging for recycling. Batteries, oil, and similar material into household substances must not enter the environment. waste;...
  • Page 4: Model Information

    Warning – Damage to Washer can occur if left running. Do not leave the Washer running in bypass for extended periods as heat build-up can damage the pump. Do not leave unit running unattended. Warning – Never pump flammable or explosive liquids. The Washer must only be used with liquids compatible with the pump, component &...
  • Page 5: Component & Accessory Identification

    4. Component & Accessory Identification Trolley with 10" wheels Engine Pump Drive coupling guard Adjustable pressure regulator Pressure adjusting knob Inlet filter Inlet feed coupling High pressure delivery outlet Bypass outlet Figure 1. Washer Components Suction hose and filter Bypass hose Figure 2.
  • Page 6: Pre-Operation Set Up

    5. Pre-Operation Set Up • Unpack and make sure that the Washer is complete and undamaged. If the Washer appears damaged in any way, do not use the machine and consult your dealer. • Check engine oil is at correct level as specified in the engine manufacturer’s handbook. Warning –...
  • Page 7: Start Up / Shut Down Procedure

    6. Engine Start Up / Shut Down Procedure • Consult the accompanying Honda user manual for full engine checks and start up and shut down procedure Note – Before starting and after stopping the Washer depress the lance trigger to release system water pressure.
  • Page 8: General Maintenance Information

    General Use • Open and close the lance trigger to start/stop the flow of water as required. • The washer is fitted with a return-to-tank pressure regulating valve which bypasses excess fluid back to the supply tank during normal use and when the lance trigger is closed NOTE –...
  • Page 9: Storage Information

    9. Storage Information The Washer & accessories should be stored in a dry and frost proof location. Frost can lead to serious component damage which is not covered by warranty. Disconnect all hoses, lances and accessories and drain water. Crank the engine over using the recoil start to expel water from pump. Ensure all equipment is clean and dry.
  • Page 10: Warranty Information

    9. Warranty Information Limited Warranty Supplied by Dual Pumps Ltd Dual Pumps Ltd as suppliers warrants to the original purchaser, each new unit or other product supplied from its factory, for the period of twelve (12) months from the date of shipment from the factory, six (6) months for equipment on hire or rental), to be free from defects in material and workmanship under normal use and service.
  • Page 11 Dual Pumps Ltd will decide whether the claim is valid and if so will issue a credit for the item. Should Dual Pumps Ltd find the claimed item to be out of warranty declarations the said charge will stand and be paid by the customer as normal.
  • Page 12: Ec Declaration Of Conformity

    2000/14/EC - Outdoor Noise Directive 2014/30/EU - Electromagnetic Compatibility (EMC) Directive Manufacturer Dual Pumps Ltd, Unit 8 Hudson Road, Saxby Road Industrial Estate, Melton Mowbray, Leicestershire LE13 1BS. United Kingdom Person authorised to compile the technical file & declaration Tom Herridge, Product Manager...

Table of Contents