Advertisement
Assembly and Disassembly
Inflatable Sport Boards are manufactured to make it easy for consumers to set up and take down quick and easy.
ATTENTION! Any use of an air compressor may result in poor performance or damage to the board, and automatically
voids all warranties. If you leave your board exposed to the hot sun, check the pressure and deflate it slightly. This
could cause the board to become over inflated and stretch the material. The ambient temperature affects the tube's
internal pressure: a variation of 1°C / 1.8° F causes a variation of the pressure in the tube of +/- 4 mBar (.06psi).
STEP BY STEP INFLATION & ASSEMBLY:
Step #1.
Remove the Sport Board from the box and lay it out
on a clean flat surface with no sharp objects. Make sure the
SUP is completely spread out with nothing on it or below it
before assembly.
Step #2.
Remove the valve cover and connect the double action
pump to inflate. You can use a tube inflator to inflate 90% of the
way. Always top of the SUP with the hand pump to insure
maximum 15 PSI. (Never exceed maximum PSI)
Step by step Disassembly and Storage
1.
Follow step #1 in assembly.
2. Wipe down product completely before deflating. It is easier to clean while inflated. IMPORTANT: storing
a wet product can cause mildew, mold, and can damage the product.
3. Pushed down valve pin clockwise and down. It should stick down, and deflation should start immediately.
4. Fold from the back tail forward like a sleeping bag. Strap down and store in backpack bag.
Step #3.
Keep your feet firmly on the foot rests and start pumping.
Step #4.
Use lever on double action pump to switch between
double action and single action pumping. Double action means air
is being pumped while pulling up and pushing
down on pump handle. Single action means air is
only being pumped when pushing down on pump
handle. Use double action while inflating the tube
the first 95% of the way. Use single action to top
off the remaining 5% or when it is difficult to pump.
IMPORTANT —
Installing the 9" Fin:
Step #1.
Turn your board over and find the finbox on the
back of the board.
Step #2.
Insert the front part of the fin first into the finbox.
Step #3.
Push the fin down into the slit in the finbox.
Step #4.
Tighten the screw until you can't anymore with
your hand.
Your Inflatable Sport Board is ready to go!
5
>
Advertisement
