Advertisement
https://www.supplychimp.com
SETUP & OPERATION
OPEN THE MOBILE LOCKER AND RESET PASSCODE
The preset factory Entry Code is "0000"
1. Set the dial so that it displays "0000".
2. Rotate locking latch to the open position and
pull door open.
3. To program a new Personal Entry Code,
Locate the switch on the back of the locker
door and set it to the "Set Code" position.
4. Set the number dials on the front of the door
to your new 4-digit Personal Entry Code and
return the switch on the rear of the door to the
"On" position.
IMPORTANT: If your Personal Entry Code is forgotten, entry into the Mobile
Locker cannot be done without damaging the unit. Therefore, it is
recommended to use a code that will be easily remembered like a birthdate.
IMPORTANT: Make a note of your new Entry Code and store in a safe place.
__ __ __ __
To re-open your Mobile Locker repeat steps 1-2 using your new Personal
Entry Code instead of "0000".
SETUP & OPERATION CONTINUED
LOCK THE MOBILE LOCKER:
1. Push the door closed and rotate locking
latch downward into the locked position.
2. Set dials back to "0000" to complete locking
procedure.
1. Un-screw the tether secure knob and
1
2
2. Wrap cable around object and back
3
3. Re-insert the tether through the hole
4
4. Close and lock the Mobile Locker.
ID TAG USE
1. Write phone number and name
2
MODEL 1550 - ATTACHING SECURITY CABLE
remove the tether cable by pulling it
through the hole.
through looped end.
and attach using the tether secure knob.
2. Insert ID tag in slot on the
on ID tag
inside of the door
1
2
3
4
3. Information will be visible
through front window
3
Advertisement
