Summary of Contents for Viega 1219.6
- Page 1 Safety temperature limiter Instructions for Use for Fonterra radiant heating and cooling, pump circuit at over temperature Model Year built: 1219.6 from 01/2007 en_INT...
- Page 2 Safety temperature limiter 2 from 8...
-
Page 3: Table Of Contents
Table of contents Table of contents About these instructions for use Target groups Labelling of notes About this translated version Product information Intended use Operating mode Technical data Handling Assembly Disposal Safety temperature limiter 3 from 8... -
Page 4: Target Groups
About these instructions for use 1 About these instructions for use Trade mark rights exist for this document, further information can be viega.com/legal . found at Target groups The information in this instruction manual is directed at the following groups of people:... -
Page 5: About This Translated Version
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e. -
Page 6: Intended Use
Product information 2 Product information Intended use Contact thermostat with sensor head for limiting the temperature of Fonterra surface heating units in combination with control stations. Operating mode In case of a fault, the safety contact thermostat switches off the circula- tion pump and therefore prevents the Fonterra surface heating from overheating. -
Page 7: Assembly
Handling 3 Handling Assembly DANGER! Danger due to electrical current An electric shock can lead to burns and serious injury and even death. – Work on the electrics may only be carried out by trained electricians. – Always de-energise the connection line before work is commenced. -
Page 8: Disposal
Handling Position the safety temperature limiter at the supply after the pump or on the manifold supply beam. Fasten safety temperature limiter with steel tape. Disposal Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements.
Need help?
Do you have a question about the 1219.6 and is the answer not in the manual?
Questions and answers