Do you have a question about the ProStar and is the answer not in the manual?
Questions and answers
Leeroy
February 21, 2025
Just bought a Pro Star Night Searcher light, put it on charge, charger has turned green for fully charge, no lights show on the side and the Searchlight wont come on.
1 comments:
Mr. Anderson
February 21, 2025
If the NightSearcher ProStar light does not turn on after charging, despite the charger indicating a full charge, consider the following possible reasons:
1. Battery Not at Optimum Performance – The battery reaches optimum performance after five complete discharge/charge cycles. If it is a new unit, it may need more cycles to function properly.
2. Incorrect Charging Procedure – Ensure that the ProStar was slotted correctly into the charging base and charged for the full recommended 6 hours.
3. Power or Connection Issue – Verify that the charger and charging base are functioning correctly and that the power source is reliable.
4. Battery or Indicator Malfunction – The battery status indicator may show green, but the battery may not be holding charge properly.
5. Device Not Switched On Properly – Press the round blue button to turn it on, as described in the manual.
6. Damage or Faulty Unit – If none of the above resolve the issue, the unit may be faulty and should be checked by a qualified person.
If the problem persists, contact NightSearcher Limited or an authorized distributor for further assistance.
PROSTAR LITE - 14.8V 7.8AH BATTERY PROSTAR - 14.8V 10.2AH BATTERY The ProStar Lite has the same performance as the ProStar except it has a smaller 7.8Ah battery and shorter run times. Important: Please read these instructions carefully to ensure the safe and effective use of this product.
56mm 137mm The ProStar is supplied with a charging base, providing a convenient way to charge it. It can be used flat on a desk, or fixed on a wall or a vehicle. The charging base has three mounting holes, measurements are shown in Fig 1.
Operating The ProStar To switch ON, simply press the round blue button and the ProStar will default to Mode Full Search light. It has 9 other light modes, please follow the diagram below to activate the required light mode. ProStar Light Modes:...
ProStar Swivel Head The ProStar swivel head can be tilted by simply Designed to stand on its end for moving it up or down as required. elevated height. Attaching Shoulder Strap Supplied with a high quality adjustable shoulder strap. Making it comfortable to carry the Searchlight, whilst keeping your hands free to perform other tasks.
• Do not submerse the unit in water. • Disconnect from any power sources and switched off, before performing any routine cleaning or maintenance. • Leave servicing to a qualified person. In case of any problems or questions please contact NightSearcher Limited or an authorised distributor.
Page 8
@nightsearcher-limited Unit 4, Applied House, Fitzherbert Spur, Farlington, Hampshire, PO6 1TT, UK 023 9238 9774 www.nightsearcher.co.uk nightsearcher-limited EUROPE Garbary 53, Poznan Poland +44 239 216 1126 @NightSearcher www.nightsearcher.com @NightSearcherltd...
Need help?
Do you have a question about the ProStar and is the answer not in the manual?
Questions and answers
Just bought a Pro Star Night Searcher light, put it on charge, charger has turned green for fully charge, no lights show on the side and the Searchlight wont come on.
If the NightSearcher ProStar light does not turn on after charging, despite the charger indicating a full charge, consider the following possible reasons:
1. Battery Not at Optimum Performance – The battery reaches optimum performance after five complete discharge/charge cycles. If it is a new unit, it may need more cycles to function properly.
2. Incorrect Charging Procedure – Ensure that the ProStar was slotted correctly into the charging base and charged for the full recommended 6 hours.
3. Power or Connection Issue – Verify that the charger and charging base are functioning correctly and that the power source is reliable.
4. Battery or Indicator Malfunction – The battery status indicator may show green, but the battery may not be holding charge properly.
5. Device Not Switched On Properly – Press the round blue button to turn it on, as described in the manual.
6. Damage or Faulty Unit – If none of the above resolve the issue, the unit may be faulty and should be checked by a qualified person.
If the problem persists, contact NightSearcher Limited or an authorized distributor for further assistance.
This answer is automatically generated