Servicing; Annual Servicing; Changing Components - Benchmark Gledhill BoilerMate 2000 125 Design, Installation And Servicing Instructions

3.0 SERVICING

3.1 ANNUAL SERVICING

No annual servicing of the BoilerMate 2000
is necessary.
However, if required, the operation of the
controls and a hot water performance test can
be carried out when servicing the boiler to
prove the appliance is working satisfactorily
and within its specification.
3.2 CHANGING
COMPONENTS
Free of charge replacements for any faulty
components are available from Gledhill during
the in-warranty period (normally 12 months).
After this, spares can be obtained direct from
Gledhill using the 'Speed Spares' service, or
through any of the larger plumbers merchants/
specialist heating spares suppliers.
Help and advice is also available from the
Technical Helpline on 01253 474401.
However,all components are readily accessible
and can be changed quickly and easily by the
installer using common plumbing practice.
If it is necessary to replace any of the
pumps fitted to the appliance the pump head
(motor pack) only should be removed as
recommended by Grundfos. Assuming it is
within warranty this will be accepted by a
merchant as being covered by the Grundfos
national service exchange agreement, as long
as it is a complete pump i.e. alleged faulty
motor pack and new base is left with the
merchant. It is important when a pump
has been replaced to ensure that any air is
adequately vented.
Page 31