Sub-Zero Wolf BBQ242BI Service Manual page 25

Component Removal
FRONT CONTROL PANEL COMPONENTS:
Components include; Control Knob, Igniter Knob,
Control Panel, Rotary Igniter and Match Holder with
Lanyard.
Control Knob
To remove, pull the knob straight off of the burner valve
shaft. See Fig. 4-18
Igniter Knob
To remove, pull the knob straight off of the rotary igniter
shaft. See Fig. 4-18
Fig. 4-18
Control Panel
Begin by removing all of the control panel knobs.
Extract the screws from the bottom left and right cor-
ners of the panel. Pull the bottom of the panel out
about 30 degrees and lift slightly to disengage the top
flange of the panel from its mounting. Then lift the top
forward. See Fig. 4-19
Fig. 4-19
OUTDOOR B B BQ G G RILLS
Rotary Igniter
To remove the rotary igniter, first remove the rotary
igniter knobs and the control knobs. Remove the con-
trol panel and unplug the electrode wire from the rotary
igniter. Next extract the two screws that mount the
rotary igniter to the control panel. Then pull the rotary
igniter from the control panel.
Fig. 4-20
Match Holder with Lanyard
The match holder is used to secure a lighted match to
light the burner if the rotary igniter fails to produce a
spark. It is riveted to the bottom of the control panel.
To replace it, you will have to drill out the rivet.
See Fig. 4-21
Fig. 4-21
See Fig. 4-20