Advertisement
Quick Links
Advertisement
Summary of Contents for NCR 7705 R1.1 EBox
- Page 1 Kit Instructions 7705 R1.1 EBox 7705-K036 Issue A...
-
Page 2: Revision Record
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current. - Page 3 7705 R1.1 EBOx Introduction This kit provides components to upgrade the 7705 EBox into an NCR "XR6" Motherboard which is based on Intel's Shark Bay Platform (Intel Haswell 22nm processor with Lynx Point Q87 Chipset). The EBox also provides the following components: •...
-
Page 4: Kit Contents
7705 R1.1 EBOx Kit Contents... -
Page 5: Installation Procedure
Caution: Properly hold and support the EBox assembly while loosening and tightening the screws securing the assembly to the fascia. Perform the following procedures to install the 7705 R1.1 EBox: Removing the Existing EBox Assembly Installing the 7705 R1.1 EBox... - Page 6 7705 R1.1 EBOx Removing the Existing EBox Assembly 1. Shut down the Kiosk Operating System and turn off the Kiosk. 2. Unplug the terminal’s power cord. 3. Open the Kiosk Fascia using a key to access the EBox. 4. Take note of all cables connected to the EBox and the cable routing. Disconnect all the cables and remove them from the cable strain relief.
- Page 7 7705 R1.1 EBOx 6. Loosen the screws (4) securing the EBox assembly to the fascia then slide the EBox assembly upwards to remove the assembly. 7. Remove the screws (2) securing the EBox Mini DC Hub then remove the Mini DC Hub.
- Page 8 7705 R1.1 EBOx 8. Remove the screws (2) on each side securing the EBox to the brackets and slide the EBox upwards to remove it..
- Page 9 7705 R1.1 EBOx Installing the 7705 R1.1 EBox 1. Mount and secure the R1.1 EBox to the bracket assembly using screws (2 on each bracket). 2. Mount and partially tighten screws (2) on the EBox for the Mini DC Hub assembly.
- Page 10 7705 R1.1 EBOx 3. Slide the Mini DC Hub on the screws then fully tighten the screws (2) to secure the Mini DC Hub.
- Page 11 7705 R1.1 EBOx 4. Mount and secure the EBox assembly to the Fascia. a. Align and insert the slots of the Ebox brackets to the mounting screws positioned on the display lower bracket. b. Insert the mounting keyholes of the EBox brackets through the mounting screws positioned on the display top bracket.
- Page 12 1-10 7705 R1.1 EBOx 5. Connect the DVI connector of the HDMI to DVI cable to the Display and connect the HDMI connector to the EBox IO Panel.
- Page 13 7705 R1.1 EBOx 1-11 6. Connect the Fascia Harness Cables to the Ebox and DC Hub. a. Plug the DVD-RW cable to the eSATA connector on the side of the EBox. b. Plug the following DC cables to the Mini DC hub on the side of the EBox: •...
- Page 14 1-12 7705 R1.1 EBOx 7. Tidy up and secure the cables using cable ties and the cable strain relief bracket.