Advertisement
Quick Links
CC2530 Zigbee Wireless RF Module
General Description
CC2530 Zigbee
The
targeting compliance with worldwide radio-frequency. It's a true system-on-chip solution for 2.4-GHz IEEE802.15.4,ZigBee
applications.
Electrical Characteristics
Ta = 25°C, VCC = 3.3V
Typically, equipment utilizing this device requires emissions testing and government
approval, which is the responsibility of the equipment manufacture.
ITEM
Voltage supply
Transmitting
current
Receiving current
Sleep
consumption
frequency
Output power
Receiving
sensitivity
Data rate
Transmit distance
CC2530 Zigbee Module
RF Module is a low-power, highly integrated 2.4-GHz transceiver that suitable for systems
PARAMETER
MIN
TYPICAL
3.0
3.3
36
38
25
26
1
2.405
3.8
4.0
-97
250
100
MAX
3.6
40
27
2.485
4.2
1 / 6
UNIT
V
mA
mA
uA
GHz
dBm
dBm
Kbps
m
Advertisement
Summary of Contents for Eddy Wireless CC2530
- Page 1 CC2530 Zigbee Module CC2530 Zigbee Wireless RF Module General Description CC2530 Zigbee RF Module is a low-power, highly integrated 2.4-GHz transceiver that suitable for systems targeting compliance with worldwide radio-frequency. It’s a true system-on-chip solution for 2.4-GHz IEEE802.15.4,ZigBee applications. Electrical Characteristics Ta = 25°C, VCC = 3.3V...
- Page 2 ·IEEE 802.15.4 MAC timer, general-purpose timers (One 16-Bit, Two 8-Bit) ·32-kHz sleep timer with capture ·Watchdog timer ·21 general-purpose I/O pins (19× 4 mA, 2×20 mA) ·Hardware debug support -CC2530-Z1 RF Module ·Applications ·2.4-GHz IEEE 802.15.4 systems ·Zigbee systems (256-KB flash) ·Home/Building automation ·Lighting systems...
-
Page 3: Pin Description
CC2530-Z1 RF Module ·Package Description Pin Description Pin name Pin type Description Pin namee Pin typ Description Power DC 2.0－3.6V Ground RESET_N reset CC2530 RESET P0.0 Digital I/O CC2530 P0.0 P0.1 Digital I/O CC2530 P0.0 P0.2 Digital I/O CC2530 P0.2 P0.3... - Page 4 CC2530 P2.1 P2.2 Digital I/O CC2530 P2.2 Antenna interface 50ohm Note: 1. P2.3 and P2.4 connect to a 32768 KHz crystal. 2. Spring Antenna or PCB Antenna can be choice. 3. Read TI CC2530 datasheet for detail. 4 / 6...
- Page 5 Develop & Debug Using Zigbee base board, it is easy to develop wireless application. USB Interface Power selection Debug Interface Power Led Zigbee Base power supply (5～8V) RS232 IO Interface Interface communication RS485 Interface USB\232\485 SEL Led Enable Inserting Zigbee module into base board, then, Connecting computer and Zigbee base board. In computer, running Comm UART Assist or other Comm debug software, As shown in the following illustration.
- Page 6 Setting com port, Baudrate etc, Default Baudrate setting 9600, parity NONE, DataBit 8, StopBit 1. then send data, zigbee module transmit RF data, other zigbee module receive data. 6 / 6...