SawStop TSA-ODC Installation Manual

Saw Stop
WARNING: This product can expose you to chemicals including wood dust, which is known to the State of California to
cause cancer. This exposure can come from drilling, sawing, sanding or machining wood products. For more information
go to www.P65Warnings.ca.gov/wood.
For SawStop Contractor saws
with a Standard Fence Assembly
BEGIN HERE
For all SawStop cabinet saws
and for Contractor saws with
T-Glide Fence Systems
BEGIN HERE
Tools:
3 mm hex key
4 mm hex key
1.
Slide clamps D onto tube C.
D
(For all saws except Contractor saws
with Standard Fence Assemblies.)
Over-Arm Dust Collection
Installation Guide
Model: TSA-ODC
A
L-brackets
B
Tools:
Two 13 mm wrenches
lower dust tube
D
C
22" 2"
bolts
Install brackets A by replacing the bolts on
the rear rail of the contractor saw with bolts
B in the locations shown above. Reinstall
the lock washer and nut on the end of each
bolt. Continue with steps 1-6 below.
F
upper dust tube
C
clamps with
screws
C
(For a Contractor saw with a
Standard Fence Assembly.)
Continue on the back side
rear rail
B
A
short hose
G
H
long hose
D
E
splitter
D D
2"