Summary of Contents for kellermann CR 4
- Page 1 Installation and Operating Instructions Kellermann CR 4 Universal comfort flasher relay with alarm function, hazard warning system, adaptive brake light* and start assistant* *Connect and use this function at your own risk...
- Page 2 Therefore, only carry out this work yourself if you are trained to do so. If you are not, contact a professional and let him install the Kellermann CR4. If the installation is not carried out properly, short circuits (cable fire) or damage to other electronic components and destruction of the flasher relay may result.
-
Page 3: Table Of Contents
ELECTRICAL CONNECTION WARNING INFORMATION: The indicators may only be controlled by the CR4, otherwise the CR4 will be destroyed by a short circuit as soon as the indicators are activated externally to the CR4. Therefore, please pay attention: • Disable all devices that control the indicators (e.g. already existing hazard warning and alarm systems) Colour series Cross-section in mm... -
Page 4: Black
The CR4 is supplied with parallel connectors and shrinkable sleeves. To connect cables to each other, first pull one of the shrinkable sleeves over one of the cables to be connected, then slide all cable ends to be connected into a parallel connector. Crimp the sleeve with suitable pliers. Then pull the shrinkable sleeve over the connection and shrink it, e.g., with a hot air dryer. -
Page 5: Grey-Yellow
If you use a separate acoustic signal emitter, the connection is simple: Connect its positive cable to the grey-white cable (with a large cross-section) of the CR4 and its negative cable to the black-white cable of the CR4. If the original horn is to be used as a signal emitter, you must first clearly determine the positive and negative of the horn. - Page 6 page 6...
- Page 7 page 7...
- Page 8 The cable leading from the start button to the starter relay must now be connected to positive of the starter relay instead of negative, where the green cable of the CR4 is also connected. The cable at the start button input still has negative potential. Instead, it must be connected to ignition positive.
- Page 9 the ignition has been switched on beforehand. This prevents misuse by unauthorised persons. Reset reminder The control light signals at regular intervals by a fast flashing sequence that the indicator is still switched on. This reminds the driver to reset the indicator. Alarm The alarm system is activated by the ignition switch.
-
Page 10: Grey-Red
the duration of the starter operation yourself. Once the engine has started, the start assistant is deactivated. For example, you cannot restart the engine with the start assistant until the ignition has been switched off and on again once. The start assistant is intended, for example, for show vehicles or gatherings on closed private grounds. - Page 11 • Grey-white cable with small cross-section: The CR4 is not normally connected to the original horn button. If you intend to replace your original horn button with another one that is only suitable for low currents, you can connect it to the grey-white cable with a small cross-section. Prerequisite:You use the original horn as an acoustic signal emitter.The CR4 then functions as an electronic horn relay.
- Page 12 You will find our online shop with our extensive range of spare parts and accessories and a download area on our homepage www.kellermann-online.com. If you have any questions or comments, you can always contact us by email (info@kellermann-online.com) or by phone (+49 241/93 80 8-0).