American Standard UY060R9V3W Series Installer's Manual page 10

Installer's Guide
r
Blower Deck
Engagement
Hole
ENGAGEMENT
HOLE DETAIL
(Typical both sides
and blower deck)
FILTER RACK INSTALLATION FOR SIDE RETURN AIR
ON UPFLOW FURNACES (Left or Right)
NOTE:
The filter rack installation is not allowed for right side
return on the following models: *UY060R9V3 &
*UY080R9V3.
If side air return is desired, it is necessary to move the filter
rack from the bottom of the furnace and reinstall it on the
side. The following instructions should be used:
a. Open or remove the blower door.
b. Remove the filter.
c. Compress the filter rack to disengage the retaining
pins/screws from the furnace sides and slide the filter
rack out.
d. Leave the bottom panel in place.
e. After the side cutout is made following the directions
in the "Return Air Duct Connections" section on
pages 8 and 9, compress the filter rack and reinstall
in the side of the furnace. Confirm that the upper
retaining pin/screw locks into the engagement hole in
t
Furnace
Cabinet
Side
Engagement Hole
For Filter Rack
Installation With
Bottom Return
10
f. Reinstall the furnace filter on the side inserting the
y
Engagement Hole
u
BLOWER
DECK
i
RETAINING
Filter
(Both Sides)
Rack
Filter Rack
Retaining
Screw/Pin
Typical Upflow Left Side Return Filter Rack Installation
the blower deck and the lower pin/screw rests against
the side of the bottom panel. See Figures 15-19.
chamfer end first.
BOTTOM ENGAGEMENT
Filter Rack
Retaining
Furnace
Screw/Pin
Cabinet
Side
For Filter Rack
Installation With
Bottom Return
Engagement Hole
For Filter Rack
Installation With
Side Return
Furnace
Cabinet
Side
Filter Rack
Retaining
Screw/Pin
SIDE
CUTOUT
PIN
SPRINGS
FILTER
RACK
RAILS
Filter
Rack
Bottom Panel
Furnace
Blower
Deck
Filter
Rack
Assembly
BOTTOM
PANEL
INSTALLED
18-CD20D3-18