Subscribe to Our Youtube Channel
Related Manuals for VADDIO TableMIC 1
Summary of Contents for VADDIO TableMIC 1
- Page 1 Complete Manual for TableMIC Conference Room Microphones Document 411-0034-30 Rev B July 2019...
-
Page 2: Table Of Contents
Contents Overview About this Manual Features Product Compatibility What's in the Box A Quick Look at the TableMIC Microphone Installation Preparing for a Successful Audio Installation Don’t Void Your Warranty! Cabling Notes Basic Connections Configuration and Administration Configuring the Microphone's Home Button Behavior Updating Microphone Firmware From ConferenceSHOT AV or AV Bridge MATRIX PRO From EasyUSB Mixer/Amp... -
Page 3: Overview
TableMIC Conference Room Microphone (worldwide) – 999-85000-000 (black); 999-85000-000W (white) The TableMIC microphone is a component of the following conferencing bundles: ConferenceSHOT AV Bundle, TableMIC 1, silver/black – 999-99950-300 (North America), 999- 99950-301 (Europe/UK), 999-99950-309 (Australia/New Zealand) ConferenceSHOT AV Bundle, TableMIC 1, white – 999-99950-300W (North America), 999-99950- 301W (Europe/UK), 999-99950-309W (Australia/New Zealand) ConferenceSHOT AV Bundle, TableMIC 1 without speaker, silver/black –... -
Page 4: What's In The Box
TableMIC microphone (worldwide) – 999-85000-000 (black), 999-85000-000W (white/light gray) TableMIC microphone Cat-5e cable, 25 ft. (7.6 m) Contact Vaddio Technical Support if you did not receive all the items listed. Find full product documentation on the applicable product page(s) at legrandav.com. A Quick Look at the TableMIC Microphone Controls for basic conferencing functionality: Home button –... -
Page 5: Installation
Here are a few tips for avoiding common audio problems. The effective range for each Vaddio conference room microphone is about 12 ft. (3.7 m) under most circumstances. Be sure the room design includes enough microphones to provide adequate coverage. -
Page 6: Basic Connections
Pro Tip Label all cables at both ends. Basic Connections The TableMIC microphone connects to the EasyMIC port on Vaddio conferencing products using a standard Cat-5e (or better) cable up to 100 ft. (30 m). Note Cables with snag-free boots are not recommended, as they may not fit. -
Page 7: Configuration And Administration
It may require firmware updates from time to time, though. Additionally, you may wish to assign functions to the microphone's Home button, to use it as a trigger devices for the Vaddio product to which you connect Configuring the Microphone's Home Button Behavior The TableMIC microphone is a OneTouch trigger device for Vaddio conferencing products that have EasyMIC ports and use macros. -
Page 8: Updating Microphone Firmware
Only one microphone at a time can be updated. Set everything up: 1. Go to the microphone's product page on the Vaddio website and download the update file identified as the web firmware update. The filename ends in .p7m. 2. Open a browser and enter the host device's IP address to access its web interface. - Page 9 Complete Manual for TableMIC Conference Room Microphones Specify the microphone to update: 1. Navigate to the host device's System page and select the Peripherals or Microphones tab. 2. Select the port connection for the microphone to be updated.
-
Page 10: From Easyusb Mixer/Amp
You can only update one microphone at a time. Download the files you need: 1. Go to the microphone's product page on the Vaddio website and download the update file identified as the serial firmware update. The filename ends in .ldr. - Page 11 This tells you that the device is connected correctly and that you have selected the COM port to which it is connected. If your query times out, returns no response, or returns a different response than expected, contact Vaddio Technical Support to troubleshoot before proceeding.
- Page 12 Install the update: 1. From the product drop-down menu of Vaddio Loader, select the name of the microphone to be updated – CeilingMIC or TableMIC. 2. Choose ‘Select Load File’ and browse to the firmware you downloaded.
-
Page 13: Operation
Complete Manual for TableMIC Conference Room Microphones Operation When the microphone is connected to a compatible Vaddio device, the device's web interface provides controls for adjusting the microphone's performance. In some cases the device may need to be updated to the latest firmware to work properly with the microphone. -
Page 14: Specifications
Complete Manual for TableMIC Conference Room Microphones Specifications Performance Frequency Response 100 Hz to 16 KHz THD + Noise < 0.02% Dynamic Range > 90 dB Environmental and Physical Operating/Storage Temperature 32°F to 104°F (0°C to 40°C) Operating/Storage Humidity 10% to 80% (non-condensing) Maximum Cabling Distance 100 ft (30 m) Dimensions... -
Page 15: Troubleshooting
Complete Manual for TableMIC Conference Room Microphones Troubleshooting What is it doing? Possible causes Check and correct Nothing. Connected devices do The cable from the microphone Verify that the microphone cable is not recognize the microphone. to the AV or conferencing connected at both ends. -
Page 16: Compliance And Conformity Statements
(2) This device must accept any interference including interference that may cause undesired operation of the device. Changes or modifications not expressly approved by Vaddio can affect emission compliance and could void the user’s authority to operate this equipment. -
Page 17: European Compliance
Complete Manual for TableMIC Conference Room Microphones European Compliance This product has been evaluated for Electromagnetic Compatibility under the EMC Directive for Emissions and Immunity and meets the requirements for a Class A digital device. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. ... -
Page 18: Warranty And Return Policy
Vaddio Customer Service: Vaddio will test, repair, or replace the product or products without charge if the unit is under warranty. If the product is out of warranty, Vaddio will test then repair the product or products. The cost of parts and labor charge will be estimated by a technician and confirmed by the customer prior to repair. - Page 19 Initial shipments of equipment that are refused upon attempted delivery, for any reason, are subject to restocking charges. The Dealer has up to 60 days from the date of purchase to return Vaddio product for credit for future purchases of Vaddio product only.
- Page 20 Returns must be made in the original Vaddio packaging with all original materials if at all possible. Vaddio products with missing original materials will be billed to the dealer at dealer price.
- Page 21 Repair Charge Estimates: Estimates on repair charges for a specific problem will not be given before an RMA is issued and the actual product has been evaluated by a Vaddio technician. Repair estimates will be given after the repair department receives and evaluates the unit.
-
Page 22: Photo Credits
Complete Manual for TableMIC Conference Room Microphones Photo Credits This guide may include some or all of these photos. European Space Agency (ESA) astronaut Samantha Cristoforetti, a Flight Engineer with Expedition 42, photographs the Earth through a window in the Cupola on the International Space Station By NASA - https://blogs.nasa.gov/ISS_Science_Blog/2015/03/06/women-in-space-part-two-whats- gender-got-to-do-with-it/, Public Domain, https://commons.wikimedia.org/w/index.php?curid=38834990 Carl Sagan, Bruce Murray, Louis Friedman (founders) and Harry Ashmore (advisor), on the occasion of... -
Page 23: Index
precautions 3 for operating the system 3 Index product returns and repairs 16 regulatory information 14 anatomy of the microphone 2 RJ-45 connectors 3 buttons and indicators 2, 11 software update 6-10 solving problems 13 storage environment 13 cable connectors 3 CE standards statement 14 cleaning 13 technical specifications 12... - Page 24 ©2019 Legrand AV Inc. Vaddio is a registered trademark of Legrand AV Inc. All other brand names or marks are used for identification purposes and are trademarks of their respective owners. All patents are protected under existing designations. Other patents pending.
Need help?
Do you have a question about the TableMIC 1 and is the answer not in the manual?
Questions and answers