Soundstream EXC.4 Owner's Manual page 5

TWEETER
1) Remove the tweeter's plastic backplate
SURFACE
MOUNTING
2) Mark the location in which you are going
3) Mount the backplate with the two 1/2" flat
4) Feed the wires through the holes and
TWEETER
1) Remove and discard the tweeter's plastic
ANGLE
2) Drill out the appropriate holes in the back
MOUNTING
3) Mount the angle mount backplate with the
4)
by separating the plate from the tweeter
housing with your two thumbnails at one
of the terminal locations, gently prying
the two pieces until they snap apart.
See Figure 3.
to mount the tweeter using the supplied
template and drill holes for each of the
two wires. Also drill small "pilaf' holes for
the two mounting screws.
head screws. See Figure 4 below.
attach them to the speaker wires going
to the crossover. Position the tweeter
over the backplate and then simply snap
it back on. Be sure to feed the Red wire
through the (+) marked hole.
backplate as described above.
of the angle mount. Mark the location in
which you are going to mount the tweeter
using the supplied template and drill holes
for each of the two wires. Also drill small
"pilot" holes for the two mounting screws.
two 1/2" flat head screws. See Figure 5.
Feed the wires through the holes and
attach them to the speaker wires going to
the crossover. Position the tweeter over
the backplate and then simply snap it back
on.
4
FIGURE
3
FIGURE 4
FIGURE 5