Selecting A Pre-Programmed Driver Profiles (Throttle / Brake Settings) - Carson Dragster Sport Instruction Manual

13. Selecting a pre-programmed driver
profiles (throttle / brake settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at
the time when you selected the type of battery.
Driver profile
GB
Cut-Off
Reverse
travel
Percentage
reverse
travel
Maximum
braking
performance
Parking
brake
Dead Band
• Press the SET button down until all of the LEDs light up. Release
the SET button again.
• All LEDs start fl ashing. This shows that you are in the mode for
setting the driver profi le.
• Press the SET button repeatedly until you reach the required
setting. All LEDs fl ash at the next highest speed.
• By repeatedly pressing briefl y on the SET button you can scroll
through the settings.
• When you reach the required setting, hold down the SET button
for approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs fl ash one after
the other to show that you are leaving the programming mode.
The controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
18 CARSON DRAGSTER Brushless-Regler 906008+906056
1 2
as as
selected selected
no yes
0 50
30% 30%
15% 10%
3 3
3 4
as as
selected selected
yes no
50 0
40% 40%
15% -
4 4
reset to 5
factory
defaults
OFF
yes
25
30%
10%
3