Download Print this page

i-Cruz Pro Instruction Manual

INSTRUCTION MANUAL

INSTALLATION / SETUP INSTRUCTIONS

All i-cruz bikes come fully assembled. Remove the bike from the box and remove the

protective wrapping, unfold the bike and install the pedals using a spanner to tighten

properly. (Pedals are marked L and R)

NOW charge the battery fully as it may have been stored for a lengthy period. NB always

charge battery before first use.

Table of Contents

Do you have a question about the Pro and is the answer not in the manual?

Page 1 INSTRUCTION MANUAL INSTALLATION / SETUP INSTRUCTIONS All i-cruz bikes come fully assembled. Remove the bike from the box and remove the protective wrapping, unfold the bike and install the pedals using a spanner to tighten properly. (Pedals are marked L and R) NOW charge the battery fully as it may have been stored for a lengthy period.
Page 2 UNFOLDING THE E-BIKE Unfold the bike from the centre frame out and lock the frame in position. Raise the handlebars and lock into position. Set the handlebar at required height for rider. Raise the seat to required height and lock in position using seat clamp.
Page 3 TURNING THE BIKE ON AND OFF Turn the I-Cruz Pro E-Bike on by double pressing the lightning bolt on the key remote. Turn off the bike by pressing the unlock padlock.
Page 4 COLOUR LCD DISPLAY The I-Cruz - Pro - Colour LCD display (Details Below)
Page 5 Please store battery in a cool environment. Riding in wet conditions is acceptable however warranty is void if bike is submerged in water. PARTS I-cruz stock and sell all major mechanical parts and electric components for all bikes. Rear Hub Motors LED Lights...