GENERAL INFORMATION The Status™ system has an easy to interpret LED indicator to inform drivers and technicians of the current status of a battery. A quick glance at the Status™ Controller assures the driver or technician that the batteries are ready to go, or alerts the driver that the batteries need maintenance.
Step 3: Push the Status through the 1.06 inch hole. Slide the ¾ inch NPT lock nut over the positive and negative wires and secure it to the threads on the back of the Status. P: 479.419.4800 | F: 479.419.4801 | www.purkeys.net...
Page 6
Step 4: Connect the wire marked battery negative to the negative post on the battery. Tighten battery nut. Step 5: Connect the wire with the inline fuse marked battery positive to the positive post on the battery. Tighten battery nut.
Slow Flashing Orange charge (Voltage below batteries 24.8 volts) Open ciruit from Repair circuit by battery positive and No LED repairing the wire or Status™ or disconnected replacing the fuse ground in battery box P: 479.419.4800 | F: 479.419.4801 | www.purkeys.net...
Product or failure of a part not manufactured by Purkeys. This warranty shall not apply if any Purkeys product is used for a purpose for which it is not designed or is in any way altered without the specific prior written consent of Purkeys. ANY...
Need help?
Do you have a question about the STATUS 45 VOLT and is the answer not in the manual?
Questions and answers