Summary of Contents for Heinner VSP001
- Page 1 Instructions Instrucțiuni de utilizare - RO Anleitung - D Eredeti használati utasítás - HU Ръководство за употреба - BG Instrukcja obsługi - PL www.heinner.com VSP001...
- Page 2 Electric Pressure Washer APPLICATION THE PORTABLE PRESSURE WASHING MACHINE is a highly specialized multifunctional machine with exceptionally reliable safety assurance, which must be inspected before it may be used to wash and clean cars, bikes and other outdoor equipment or garden patios, green houses etc.
- Page 3 Electric Pressure Washer 3. ALWAYS disconnect power before and pull out the plug from socket outlet, and disassembling or repairing the unit of the Disconnect the connection with water. machine. 15. The machine is not intended to be 4. Follow all safety codes as well as the connected to the potable water mains.
- Page 4 Electric Pressure Washer In a double-insulated machine, two systems environment. of insulation are provided instead of WARNING! Do not spray electrical apparatus grounding. No grounding means are and wiring. • Never disconnect the high pressure provided for a double-insulated machine, nor should grounding means be added to the discharge hose from the machine while the machine.
-
Page 5: Extension Cords
Electric Pressure Washer • Always hold gun and wand firmly when than the rating of the machine. Do not use starting and operating the machine. damaged extension cords. Examine • NEVER allow the unit to run with the extension cord before using and replace it if trigger released (off) for more than one (1) damaged. - Page 6 Electric Pressure Washer other cleaning agents or chemicals may maintenance and when replacing the machine adversely affect the safety of the machine. to another function. WARNING! High pressure jets can be WARNING! Do not use the machine if a supply dangerous if subject to misuse.
- Page 7 Electric Pressure Washer WARNING! To ensure the machine safety, If the mains cable is damaged it must be please only use original spare parts (including replaced by the manufacturer, or its service nozzle) from the manufacturer or approved by agent or similarly qualified person to avoid a the manufacturer.
-
Page 8: Adjusting Fan Pattern
Electric Pressure Washer Align holes on the bottom of the pressure 1. pressure cleaner cleaner as shown and tighten the 2 screws, as the fig. 2. water supply hose 3. water connection 4. water inlet 5. high pressure tube 6. water outlet(backside) 7. - Page 9 Electric Pressure Washer • Remove additional debris by A wide fan pattern will distribute the impact of the water over a larger area, resulting in back-flushing water through the nozzle. To excellent cleaning action with a reduced risk do this, place end of a garden hose ( with of surface damage, Large surface areas water running ) to end of nozzle for 30-60 can be cleaned more quickly using a wide...
-
Page 10: How To Avoid Damaging Surfaces
Electric Pressure Washer Another factor that determines the impact turbo nozzle combines the power of a force of the water is the distance from the narrow high impact stream and the spray nozzle to the cleaning surface. The efficiency of a 25 degree fan pattern. This swirls impact force of the water is increased as the the narrow high impact stream into a cone nozzle is moved closer to the surface. - Page 11 Electric Pressure Washer upward. This will prevent the detergent from surface. This will allow your detergent to attack sliding down and causing streaks. High the deep down dirt that has worked its way into pressure rinsing should also progress from the cleaning surface.
- Page 12 Electric Pressure Washer mixing correct concentrations of detergent to Start final rinse at bottom an work upward. water ratio through the pressure washer is Make sure you thoroughly rinse the surface approximately 5.4% (1 to 19). and that all detergent has been removed. 1.
-
Page 13: Major Technical Data
Failure to do so will reduce life of o-rings in 4. Never operate unit for more than one (1) lance. minute without spraying water. Resulting MAJOR TECHNICAL DATA ITEM VSP001 Working pressure 9MPa(90 bar) Allowable pressure 13.5MPa(135 bar) Working flow rate 5.0 l/min... - Page 14 Possible problem and solution: Symptom Possible cause(s) Corrective Action(s) No detergent suction-units 1. Lance nozzle is not in low 1. Slide lance nozzle into low with tanks presure pressure position (see page 2. High pressure extension hose or high pressure hose 2.
-
Page 15: Inspection And Maintenance
Electric Pressure Washer 5.Valves is clogged or worn Fluctuating Pressure 1.Pump is sucking in air 1.Check that hoses 2.Clogged nozzle connections are tight 3.Valves dirty,worn of suck 2.Clean with tip cleaner (see 4.Water seals worn page 8) 3.Call the dealer 4.Call the dealer Motor stops suddenly 1.Extension cord is too long or... - Page 16 Electric Pressure Washer Conformity with the RoHS Directive: the item you purchased is in conformity with the EU Directive RoHS (2011/65/UE). It does not contain materials listed as harmful or prohibited in the Directive. Thank you for helping us protect the environment and our health! Manufactured for Network One Distribution Marcel Iancu St., no.
- Page 17 Electric Pressure Washer...
Need help?
Do you have a question about the VSP001 and is the answer not in the manual?
Questions and answers