Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for SFaudio SFP-400
Summary of Contents for SFaudio SFP-400
- Page 1 SFP-400/400LED GB ‐ Instruction Manual www.sfaudio.es ...
- Page 2 GB ‐ 400W Fog Machine Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or damage due to misuse. The appliance is only to be used with the recommended vaporizing medium. The use of other substances may give rise to a toxic or fire risk. This appliance shall not be used by children below the age of 14 nor persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge even if they have been given supervision ...
- Page 3 • Remove all fog liquid from the unit before transport. • Don’t swallow fog liquid. In case of accidental ingestion, contact immediately a doctor. Rinse thoroughly your skin and eyes if they have been in contact with the fog liquid. Installation: 1. Take away all packing material especially in the nozzle. 2. Set the unit on a level surface and loosen the cap of the fluid tank. 3. Add high quality water based fog liquid in the machine and screw the cap of the fluid tank. Bad quality fog liquid will damage fog machine. 4. Plug the unit into an earthed mains outlet. Operation: 1. Please turn on the unit via the switch on the rear panel. The machine will start heating up. Set the I/O switch on the remote to “I” to start the fog machine. When it has reached operating temperature, the neon switch on the remote control lights up. Occasionally the neon switch will turn off and the pump will stop. This means that the unit has cooled down and requires re‐ heating, the pump will not operate whilst the heater is on and the switch will illuminate when the machine is again ready to use. 2. Often check whether there has enough fog liquid in machine. The operation will make big damage to the machine if there has no fog liquid. 3. If the fog output is low, the unit makes an unusual noise or there is no fog output at all, please power off and check fog liquid, fuse and power plug. If the problem hasn’t been solved after checking these parts, send it back to your dealer for repair. ...
- Page 4 Others: Clean timely to extend the lifespan of machine. Use dry cloths to clean machine and keep dry while store. SFP400 SFP400 LED Voltage 230V AC 230V AC Power 400 W 400 W Fuse 5 A 5 A Pre‐ Heating time 5 min 5 min Out Volume 100 m3/min 120 m3/min Thank 0.5 Litre 0.6 Litre Remote wire Quantity LED´s Weight 2.2 kg 2.5 kg Packaging (mm) 215 x 150 x 115 225 x 160 x 120 Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local authorities or your dealer about the way to proceed ...
Need help?
Do you have a question about the SFP-400 and is the answer not in the manual?
Questions and answers