Switch on
− Press the ON/OFF button
Both of the bottom lamps light up. The heating function for the upper body and
the calf/foot area is switched on at the lowest level (default setting).
Select heat level and heating zones
Functional principle
When pressing with the TEMP
• briefly pressed: Select temperature
• pressed for a long time (approx. 4 seconds): Select heating zones/confirm
selection
• The left LEDs flash, if the upper heating zone is selected by pressing TEMP for a
long time. If no button is pressed, the left LEDs start to flash approx. 9 seconds
later. Only the right LEDs are active for adjustment by default.
After switching on
− By pressing TEMP repeatedly, select the heating level for the upper body.
The LEDs indicate which heating level you have currently set.
− If you keep TEMP pressed for several seconds, instead of briefly pressing it, the
left bottom LED flashes.
− By pressing TEMP repeatedly, you can now set the temperature for the calf/foot
area.
− If you keep the TEMP button pressed for a long time, the control unit switches to
the adjustment option for the right LEDs. You can select this by briefly pressing
the TEMP button.
− If you have set the left heating level (flashing LEDs) and wait briefly (9x flashes),
the setting is stored for the calf/foot area. Then, you can adjust the temperature
range for the upper part of the body, as standard.
Switching off
1. Press the ON/OFF button
2. Pull out the power cable in order to completely disconnect the double electric
blanket from the power supply.
The blanket switches itself off automatically after 3 hours. If you do
not want the double electric blanket to switch back on, remove the
power plug from the socket.
6
to switch on the double electric blanket.
button, the following applies:
5
6
to switch off blanket. at a specific time.
Use
15