Table of Contents
Advertisement
Quick Links
RF wireless wall mounted RGB/W controller
Parameter
Remote
Operation Voltage
Part No.
ML-2820-US3
100-240VAC
Receiver(purchased separately)
Part No.
Iuput Voltage
ML-1009FAWi
12-36VDC
Product Size
75.0
ML-2820-US3
Feature
3 zones
Sensitive Glass Touch Panel
RF Signal
5
Operation
DIMENSIONS
Frequency
ø/h (mm)
Touch Sensor
434MHz
120x75x29.1
Current
Output
4x5A
Constant voltage
4x(60-180)W
Installation
Button introduction
Color Wheel:
Touch to choose color
Remarks
Warm white & Cold White &
Natural White, mixed by RGB
Brightness
Remarks
Zone Number:
Short touch 1. 2 . 3 to choose the zone
Long touch 1. 2 . 3 to switch on/off
Wiring diagram
1)Sender
Connection
L
110V-230VAC
N
Diagram
ML-2820-US3
L
L
N
N
Short
touch
to choose the color R.G.B.W
Long touch to dim brightness of R.G.B.W
Switch: Short
touch
to switch on/off
Color Running Button:
Short touch to start or Pause color
running mode;
Long touch to adjust speed (10 built-in
color running modes)
Advertisement
Table of Contents
Summary of Contents for M-Elec ML-2820-US3
- Page 1 RF wireless wall mounted RGB/W controller Installation ML-2820-US3 Feature 3 zones Sensitive Glass Touch Panel RF Signal Button introduction Color Wheel: Touch to choose color Short touch to choose the color R.G.B.W Parameter Long touch to dim brightness of R.G.B.W...
- Page 2 5 seconds until the LED device connectedwill flash to confirm all learned controllers have been removed. Note 2: Each ML-2820-US3 controller can control unlimited receivers within the Radio Frequency range. Note 3: Master/ Slave option is set via the jumper pin, closed is Master with an open jumper is set to Slave, set on the receiver ML-1009FAWI.
Need help?
Do you have a question about the ML-2820-US3 and is the answer not in the manual?
Questions and answers