Table of Contents
Advertisement
• To exit Quick Load, press either a
number with a CD in it or LOAD.
Quick Unload
• Press EJECT (
) for two seconds;
all CDs will eject from highest
number to lowest.
Load 1 CD
• Press LOAD; all available numbers
will flash amber.
• Select the number desired.
• Wait for amber lights to flash on
sides of slot before inserting CD.
• Repeat to load more CDs.
Unload 1 CD
• Press EJECT.
• Press number for CD desired.
Play a CD
• Option 1: Press the number for
the CD desired in the six-disc CD
changer (wait eight seconds).
• Option 2: Press 5/SIDE button on
radio face to scroll through CDs.
Select CD Track
• Option 1: PREV/NEXT on radio.
• Option 2: SEEK arrows on radio.
• Option 3: SEEK arrows on steering
wheel.
Refer to Owner Manual for further information.
Driver
Seats and
Information
Mirrors
Note: CDs with any labels may jam in the
CD player. Label a CD using a permanent
marker. If more than one CD is inserted
into the slot at one time, or if scratched or
damaged CDs are played, the CD player
could be damaged. When using the CD
player, use only CDs in good condition
without added labels; load one CD at a
time; and keep the CD player and the
loading slot free of foreign materials,
liquids and debris.
REAR SEAT ENTERTAINMENT (RSE)
SYSTEM (if equipped)
The DVD player is located in the
second-row overhead console and the
system comes with two wireless
headphones. The DVD player can be
controlled by the buttons on the DVD
Automatic
Entertainment/
Climate
Convenience
Controls
Features
player and by the buttons on the
remote control. Reference your Owner
Manual for detailed instructions. The
DVD player power may be turned on
when the ignition is in RUN,
ACCESSORY, or when Retained
Accessory Power (RAP) is active.
UNIVERSAL HOME REMOTE
Program Universal Home Remote
Your vehicle's engine should be turned
off while programming the remote.
Follow these steps to program up to
three channels:
1. Press and hold down the two
outside buttons (see next page),
releasing only when the indicator
light begins to flash, after 20
seconds. Do not hold down the
buttons for longer than 30 seconds
and do not repeat this step to
program a second and/or third
transmitter to the remaining two
remote buttons.
2. Position the end of your hand-held
transmitter about 1 to 3 inches (3
to 8 cm) away from the remote
buttons while keeping the
indicator light in view.
Drive and
Vehicle
Security
Personalization
Systems
Utility
Owner
Enhancement
Privileges
TM
System
7
Advertisement
Table of Contents
