Table of Contents
Advertisement
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Get parts or technical assistance online at
www.GetEarthquake.com or call (800) 345-6007
Owner's Manual
MC33
2-Cycle Cultivator
Model #: 31635
SERIAL NO.
DATE OF PURCHASE:
© 2018 Ardisam
All Rights Reserved
REV 2: 10/17/2018
GAS/OIL
RATIO
50:1
P/N: 31674
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MC33 and is the answer not in the manual?
Questions and answers
Culivator is a little over 3 yrs old (12/21) Perhaps 5 hours of small garden use Good engine power but poor tine performance. Tines work best at medium engine power but slow or stop at higher power hard to believe bad clutch with so few hours
Poor tine performance in an EarthQuake MC33 cultivator with low usage hours could be caused by several factors:
1. Loose or Missing Fasteners – Ensure that all screws, nuts, and bolts are tight.
2. Debris Build-Up – Check and remove any debris around the tines, air cleaner holes, and gas cap.
3. Improper Tine Installation – Verify that the tines are correctly installed and secured with hairpins.
4. Low Grease Level – Check the transmission case grease level and add molylithium type grease if necessary.
5. Fuel Issues – Ensure the correct fuel mixture (50:1 gas-to-oil ratio) and that the fuel tank is not overfilled.
6. Spark Plug Issues – Inspect and clean the spark plug area or replace the spark plug if needed.
If none of these resolve the issue, further inspection of internal components may be required.
This answer is automatically generated
How to start
Spark plug wire will not stay connected
I cant get the sleeve to unlock on the wheel height adjustment on mc33