Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for soloprotect Go
- Page 1 Quick Start Guide...
- Page 2 Charging Function: Keeps the SoloProtect Go battery fully charged. How to use: Insert the SoloProtect Go charger lead into the indicated Micro USB socket (behind removable section and indicated by the USB charge symbol). The maximum battery life is 72 hours if fully charged.
-
Page 3: Turning On/Off
How to use: On: Press the highlighted Power button for a minimum of three seconds. The device will emit a beep, and a single vibration. Once on, SoloProtect Go will automatically perform a ‘Device Check’. Off: Press the highlighted Power button for a minimum of five seconds. -
Page 4: Device Check
SIM card read has been unsuccessful and/or that the device has no signal. Geolocation: A flashing blue LED indicates a location fix has been successful. A solid blue LED indicates a location fix has not been successful. • Please note, all LEDs will go out after a period of inactivity. Quick Start... - Page 5 When your ‘Amber Alert’ is connected, you will feel a single vibration. After which, you are free to begin your message. You have 20 seconds to leave your ‘Amber Alert’, before SoloProtect Go will automatically complete and disconnect the call.
-
Page 6: Red Alert
Red Alert Function: Use ‘Red Alert’ any time you feel your personal safety is being compromised*. How to use: Press the highlighted button for a minimum of three seconds to activate a ‘Red Alert’. The device will give three short vibrations to indicate the ‘Red Alert’... - Page 7 Function: Incapacitation detection is used to raise an alert if you have fallen or collapsed. How to use: SoloProtect Go will detect a potential incapacitation scenario if it detects movement indicating a potential, sudden fall. The device will enter a pre-alarm phase for sixty seconds - all LEDs will flash and the device will emit alarm tones and vibrate continuously.
- Page 8 (Please note, holding the button down will turn the device off). Geolocation: A flashing blue LED indicates a location fix has been successful. A solid blue LED indicates a location fix has not been successful. • Please note, all LEDs will go out after a period of inactivity. Quick Start...
- Page 9 • Keep your SoloProtect Go clean and avoid unnecessary knocks or drops. • SoloProtect Go is water resistant; but you should avoid water immersion, as that will break the device. • Please charge your SoloProtect Go every 24 hours if possible.
- Page 10 WE MAKE WORKING ALONE SAFER Tel: 0114 399 6000 (Option 4) info@SoloProtect.com www.SoloProtect.com...
Need help?
Do you have a question about the Go and is the answer not in the manual?
Questions and answers
I have a new solo go for the past week and the Blue geo light remains on all the time. No matter where I go a try a test, it remains steady on.
The blue geo light stays on continuously on the SoloProtect Go because a location fix has not been successful.
This answer is automatically generated